JNTUH B-Tech EEE 2-2 2019 Bloom’s Taxonomy Question Paper (JNTU-Hyderabad)

JNTU Hyderabad (JNTUH) B-Tech 2019 Question Papers Second Year Second Semester (2-2) Electronic and Communication Engineering (ECE)

EC405ES Blooms Taxonomy- Analog Communications Question Papers   Download

Code No: EC405ES
JAWAHARLAL NEHRU TECHNOLOGICAL UNIVERSITY HYDERABAD
B.Tech II Year II Semester Examinations, 2019
ANALOG COMMUNICATIONS
Time: 3 Hours Max. Marks: 75

Note: This question paper contains two parts A and B.
Part A is compulsory which carries 25 marks. Answer all questions in Part A.
Part B consists of 5 Units. Answer any one full question from each unit.

PART A ( 25 Marks)
Question Bloom’s Level  Example L1 And L2

1.a) Define amplitude modulation and give its time domain representation. L1
b) Compare AM, DSBSC and SSBSC modulation techniques L2
c) Give mathematical equation of SSB-SC signal and draw the spectrum. L1
d) A SSB transmitter radiates 0.5 kW when the modulation percentage is 60. How
much of carrier power (in kW) is required if we want to transmit the same
message by an AM wave? L2
e) Write the expression for instantaneous value of FM wave and define modulation
index. L1
f) Compare AM and FM techniques. L2
g) Define Noise Figure and highlight its significance. L1
h) Discuss how Average Noise Figure of cascaded networks can be obtained. L2
i) What is AGC? Mention its function. L1 / L2
j) Define selectivity and sensitivity of a Radio receiver. L2

PART B ( 50 Marks)
Question Bloom’s Level  Example L2, L3, L4  And L5

2. Explain square law modulation of AM with neat circuit diagram, time domain
expression, frequency domain expression and spectrum. L2 / L3

OR

3. Show that synchronous and Costas demodulators can be used to obtain the
message signal from DSB- SC wave. L3 / L4
R16
4. Show that, SSB signal can be demodulated by only synchronous detection. Write the
time domain expression, frequency domain expression and spectrum of the recovered
signal. L3 / L4

OR

5. It is required to transmit a TV signal for long distance. Identify a suitable analog
modulation technique and explain the generation of the identified technique.
L3 / L4
6.a) A 20 MHz sinusoidal carrier frequency is frequency modulated by m(t) = A m
cos(2πfmt), such that peak frequency deviation is 100KHz. Determine modulation
index and transmission bandwidth if f m = 50KHz and 500KHz.
L3 / L4
b) With a neat diagram and characteristics explain, Balanced discriminator used to
recover the message signal from FM wave. L3 / L4

OR

7.a) Explain the direct method of generating FM waves L3 / L4
b) A sinusoidal signal of 5 volts and 1 kHz is applied to an FM generator that has a
frequency sensitivity constant of 40Hz/volt. Find the frequency deviation and
modulation index of FM wave.
L3 / L4
8.a) Explain the representation and analysis of narrowband noise effect in analog
communication system.
L3 / L4
b) What is the need for pre-emphasis and de-emphasis. L3 / L4

OR

9.a) Discuss the effect of noise in AM system. L3 / L4
b) Define noise. Explain thermal noise and white Gaussian noise. L3 / L4
10.a) Discuss the principle of TDM. L2
b) Discuss the operation of amplitude limiter used in FM demodulators. L3 / L4

OR

11.a) Draw the waveforms for PAM, PWM and PPM L2
b) Explain the generation of PAM with neat waveform and relevant equations. L3 / L4

All the question papers are uploaded in PDF format. When you click on the question paper link, a new window will open with question paper embedded in it. If in case you do not have PDF viewer installed in your system, you can download Adobe reader from official site.

If you face any trouble viewing the question papers or for any suggestions you are most welcome to post in the comments section below.

Please do share our post to your near & dear. Please note that all our content is free of cost.