PTU B.Tech Electrical Engineering 2nd Semester May 2019 71536 ELECTRICAL MEASUREMENT and INSTRUMENTS Question Papers

Roll No.

Total No. of Pages : 02

Total No. of Questions : 09

--- Content provided by​ FirstRanker.com ---

B. Tech. (EE) PT

(Sem.-2)

ELECTRICAL MEASUREMENT & INSTRUMENTS

Subject Code : BTEE-303

M.Code: 71536

--- Content provided by⁠ FirstRanker.com ---

Time: 3 Hrs.

Max. Marks : 60

INSTRUCTIONS TO CANDIDATES :

1. SECTION-A is COMPULSORY consisting of TEN questions carrying TWO marks each.
2. SECTION - B & C. have FOUR questions each.

--- Content provided by⁠ FirstRanker.com ---

3. Attempt any FIVE questions from SECTION B & C carrying EIGHT marks each.
4. Select atleast TWO questions from SECTION - B & C.

SECTION-A

Q1. Answer briefly :

1. State the advantage of AC potentiometers.

--- Content provided by⁠ FirstRanker.com ---

2. List SI units of at least six parameters
3. What are active and passive bridge circuits?
4. What are leakage current effects?
5. What is electromagnetic interference in instruments?
6. How the current transformer and potential transformer are connected in a circuit?

--- Content provided by⁠ FirstRanker.com ---

7. How the range of instrument can be extended in PMMC instruments?
8. State the advantages of Dynamometer type instruments.
9. What do you meant by hysteresis?
10. What is electromagnetic interference in instruments?

SECTION-B

--- Content provided by‍ FirstRanker.com ---

Q2. Describe the circuit of Maxwell bridge used for measurement of inductance. Derive the conditions for balance.

Q3. Give the construction and principle of operation of potential transformer.

Q4. Describe the construction and working of PMMC instrument. Derive the equation for deflection if the instruments are spring controlled.

Q5. Describe the step by step method for determination of BH curve of a magnetic material.

SECTION-C

--- Content provided by​ FirstRanker.com ---

Q6. Describe with help of suitable diagrams. How a DC potentiometer can be used for calibration of voltmeter, Ammeter and wattmeter?

Q7. a) Discuss the ratio and phase angle errors in CT and PT, how they can be minimized.

b) Discuss the advantages and limitations of electromagnetic interference in measurements.

Q8. a) Describe the construction and functioning of self balancing potentiometer.

b) Explain with neat circuit diagram the working of successive approximation type self-balancing potentiometer.

--- Content provided by‌ FirstRanker.com ---

Q9. Write short note on followings :

1. Dynamometer
2. Hays Bridge

NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any page of Answer Sheet will lead to UMC against the Student.

FirstRanker.com

--- Content provided by‌ FirstRanker.com ---