PTU B.Tech ECE 4th Semester May 2019 57597 PULSE WAVE SHAPING AND SWITCHING Question Papers

Firstranker's choice

www.FirstRanker.com

Roll No.

--- Content provided by​ FirstRanker.com ---

Total No. of Pages : 02

Total No. of Questions : 09

B.Tech.(ECE / ETE) (2011 Onwards) (Sem.-4)

PULSE WAVE SHAPING AND SWITCHING

Subject Code : BTEC-405

--- Content provided by FirstRanker.com ---

M.Code: 57597

Time: 3 Hrs. Max. Marks : 60

INSTRUCTIONS TO CANDIDATES:

1. SECTION-A is COMPULSORY consisting of TEN questions carrying TWO marks each.
2. SECTION-B contains FIVE questions carrying FIVE marks each and students have to attempt any FOUR questions.

--- Content provided by‌ FirstRanker.com ---

3. SECTION-C contains THREE questions carrying TEN marks each and students have to attempt any TWO questions.
4. Any missing data can be assumed appropriately.

SECTION-A

1. Answer briefly :
   1. Differentiate between RC low pass and RC high pass filter.
   2. Write the output voltage expression and draw input and output waveform for the input voltage (Vmsinot) applied to a pure inductor.

   --- Content provided by‌ FirstRanker.com ---

   3. What is the role of feedback in electronics circuits.
   4. What do you mean by self bias bistable multivibrator?
   5. What is the difference between average and RMS values.
   6. Define resolution time in multivibrator.
   7. Define switching time in PN diode.

   --- Content provided by​ FirstRanker.com ---

   8. Define UTP and LTP.
   9. Differentiate between linear and non-linear wave-shaping circuits.
   10. List the applications of attenuator.

SECTION-B

--- Content provided by FirstRanker.com ---

2. The fig shows double Clipper circuit. Determine its output waveform. Assume diode drop of 0.7 V with sinusoidal input with ° 20 V. Also VB1 and VB2 are 4V and 9V respectively.

R1
D1           D2
Vi           Vo
+

--- Content provided by FirstRanker.com ---

3. Explain the working of bistable multivibrator as “T” flip flop?
4. State and prove Clamping Circuit Theorem.
5. Explain the working of Schmitt trigger.
6. How the BJT work as switch?

--- Content provided by‌ FirstRanker.com ---

SECTION-C

7. With waveforms, derive the expression for the frequency of oscillation of an astable multivibrator.
8. Derive the response of low pass RC circuit for pulse input voltage and draw the waveform.
9. Explain any two with necessary diagrams :
   1. Passive and active elements
   2. Positive and negative clamper

   --- Content provided by‌ FirstRanker.com ---

   3. Diode comparator

NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any page of Answer Sheet will lead to UMC against the Student.

www.FirstRanker.com

--- Content provided by⁠ FirstRanker.com ---