PTU B.Tech Automobile Engineering? 6th Semester May 2019 71220 AUTOMOTIVE AERODYNAMICS Question Papers

PTU Punjab Technical University B-Tech May 2019 Question Papers 6th Semester AE Automobile Engineering?

www.FirstRanker.com
www.FirstRanker.com
Roll No.
Total No. of Pages : 02
Total No. of Questions : 09
B.Tech.(AE) (2011 Onwards) (Sem.?6)
AUTOMOTIVE AERODYNAMICS
Subject Code : BTAE-604
M.Code : 71220
Time : 3 Hrs. Max. Marks : 60
INSTRUCTION TO CANDIDATES :
1.
SECTION-A is COMPULSORY consisting of TEN questions carrying T WO marks
each.
2.
SECTION-B contains FIVE questions carrying FIVE marks each and students
have to attempt any FOUR questions.
3.
SECTION-C contains T HREE questions carrying T EN marks each and students
have to attempt any T WO questions.

SECTION-A
1.
Answer briefly :

(a) What do you mean by laminar flow?

(b) What do you mean by wage reason?

(c) What are different modes to cool the engine?

(d) Does the shape of a vehicle effect the efficiency?

(e) What is the usewww.FirstRanker.com
of fasteners?

(f) What is the range for rear wind shield angle?

(g) Write the ways used to eliminate or reduce the vehicle wind noise.

(h) Draw the stability diagram showing all the moments of the vehicle taking a turn on a

banking curved road. Also consider the side wind effect.

(i) What is the main limitation of simulation?

(j) What do you mean by scaled models?
1 | M - 7 1 2 2 0

( S 2 ) - 1 1 5 3
www.FirstRanker.com

www.FirstRanker.com
www.FirstRanker.com
SECTION-B
2.
Describe the process of cooling of transverse and rear engine.
3.
Explain the car as a bluff body also discuss the different types of drag forces on it.
4.
Explain the effect of dirt accumulation on the vehicle.
5.
Write a short on Fast Back and Square Back.
6.
Explain the different measurement techniques used in wind tunnel and also describe the
equipments used for it.

SECTION-C
7.
With the help of a suitable example, explain the stress calculation for a full-scale wind
tunnel model. Also mention the equipments and transducers used for the same.
8.
Explain with a neat sketch, how front-end modification helps the vehicle to reduce the
drag. Also explain the dust flow pattern at the rear of a vehicle.
9.
Explain the following terms in detail :

a) Bluff body

b) Low drag profile

c) Drag coefficie www.FirstRanker.com
nt




NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any
page of Answer Sheet will lead to UMC against the Student.
2 | M - 7 1 2 2 0

( S 2 ) - 1 1 5 3
www.FirstRanker.com

This post was last modified on 04 November 2019