FirstRanker Logo

FirstRanker.com - FirstRanker's Choice is a hub of Question Papers & Study Materials for B-Tech, B.E, M-Tech, MCA, M.Sc, MBBS, BDS, MBA, B.Sc, Degree, B.Sc Nursing, B-Pharmacy, D-Pharmacy, MD, Medical, Dental, Engineering students. All services of FirstRanker.com are FREE

📱

Get the MBBS Question Bank Android App

Access previous years' papers, solved question papers, notes, and more on the go!

Install From Play Store

Download JNTUA B.Tech 4-2 R15 2019 July Advanced Supple 15A03804 Power Plant Engineering Question Paper

Download JNTUA (JNTU Anantapur) B.Tech R15 (Bachelor of Technology) 4th Year 2nd Semester 2019 July Advanced Supple 15A03804 Power Plant Engineering Previous Question Paper || Download B-Tech 4th Year 2nd Sem 15A03804 Power Plant Engineering Question Paper || JNTU Anantapur B.Tech 4-2 Previous Question Paper || JNTU Anantapur B.Tech ME 4-2 Previous Question Paper || JNTU Anantapur B.Tech CSE 4-2 Previous Question Paper || JNTU Anantapur B.Tech Mech 4-2 Previous Question Paper || JNTU Anantapur B.Tech EEE 4-2 Previous Question Paper || JNTU Anantapur B.Tech ECE 4-2 Previous Question Paper

This post was last modified on 10 September 2020

JNTU Anantapur B-Tech 4-2 last 10 year question papers 2010 -2020 -All regulation- All branches- 4th Year 2nd Sem


Firstranker's choice

Code: 15A03804

FirstRanker.com

--- Content provided by‌ FirstRanker.com ---

B.Tech IV Year II Semester (R15) Advanced Supplementary Examinations July 2019

POWER PLANT ENGINEERING

(Mechanical Engineering)

Time: 3 hours

Max. Marks: 70

--- Content provided by⁠ FirstRanker.com ---

PART - A

(Compulsory Question)

Answer the following: (10 X 02 = 20 Marks)

(a) Explain the principle of harnessing nuclear energy.

(b) How important is cost analysis of a power plant? Explain.

--- Content provided by‌ FirstRanker.com ---

(c) Explain the necessity of a proper draught system.

(d) What is enthalpy of steam? Write an expression for enthalpy of a superheated steam.

(e) Draw neat sketch of an IC engine and label its parts.

(f) List the different methods to improve efficiency of a gas turbine plant.

(g) List the different types of gates used in dams.

--- Content provided by‌ FirstRanker.com ---

(h) Explain the function of surge tank.

(i) List the advantages of non-conventional sources over conventional sources.

(j) Give a note of usage of graphite in nuclear reactors.

PART - B

(Answer all five units, 5 X 10 = 50 Marks)

--- Content provided by‍ FirstRanker.com ---

UNIT - I

2 Give a note on the scenario of power generation from renewable sources in India.

OR

3 Define load factor. A power station supplies the following loads to the consumers.

Time in hrs 0-6 6-10 10-12 12-16 16-20 20-22 22-24

--- Content provided by FirstRanker.com ---

Load in MW 30 70 90 60 100 80 60

(i) Draw the load curve and estimate the load factor of the plant.

(ii) What is the load factor of a standby equipment of 30 MW capacity if it takes up all the loads above 70 MW. What is the use factor?

UNIT - II

4 (a) Explain with neat sketch the working principle of out plant handing of coal.

--- Content provided by​ FirstRanker.com ---

(b) Explain how waste heat recovery is achieved in modern boilers.

OR

5 (a) Explain with neat sketch the working principle of overfeed stoker.

(b) Explain the neat diagram the working principle of cyclone furnace.

UNIT - III

--- Content provided by FirstRanker.com ---

6 Explain with suitable diagram the working of diesel power plant.

OR

7 An open cycle constant pressure gas turbine plant consists of two turbines with perfect intercooling and a two stage turbine with a reheater. Air enters at 1 bar, 15°C. The maximum pressure ratio and the maximum temperature of the cycle are limited to 5 and 800°C respectively. The reheating takes place at 2.3 bar to 800°C. The isentropic efficiencies of each compressor and each turbine are 0.8 and 0.9 respectively. The calorific value of fuel is 42 MJ/kg. Taking Cp = 1.005 kJ/kgK and y = 1.33 for gases and neglecting pressure and heat losses and if the flow rate of air is 25 kg/s, estimate: (i) The overall thermal efficiency of the plant. (ii) The air fuel ratio. (iii) The specific fuel consumption. (iv) Power output of the plant.

FirstRanker.com

Contd. in page 2

--- Content provided by​ FirstRanker.com ---

Firstranker's choice

Code: 15A03804

FirstRanker.com

UNIT - IV

FirstRanker.com

--- Content provided by‍ FirstRanker.com ---

8 Give a note on hydroelectric power plant generation in India and its future with neat diagram.

OR

9 (a) A Pelton wheel driven by two similar jets transmits 4000 kW to the shaft while running at 400 rpm. The head from the reservoir level to the nozzle is 200 m and the efficiency of power transmission through the pipelines and nozzles is 90%. The jets are tangential to a 1.50 m diameter circle. The relative velocity decreases by 10% as the water traverses the buckets, which are so shaped that they would, if stationary, deflect the jet by 165°C. Neglecting the windage losses, estimate: (i) The efficiency of the runner. (ii) The diameter of each jet.

(b) Explain classification of dams and spillways.

UNIT - V

--- Content provided by‌ FirstRanker.com ---

10 Differentiate between solar thermal and solar photovoltaic. List the different types of solar collectors and explain any one of them with a neat sketch.

OR

11 (a) Differentiate between heavy water reactors and gas cooled reactors.

(b) With a neat sketch, explain the working of a pressurized water reactor.


--- Content provided by FirstRanker.com ---


This download link is referred from the post: JNTU Anantapur B-Tech 4-2 last 10 year question papers 2010 -2020 -All regulation- All branches- 4th Year 2nd Sem