Download JNTUA (JNTU Anantapur) B.Tech R13 (Bachelor of Technology) 1st Year 1st Semester (1-1) 2017 Dec Supply 13A99101 Basic Electrical and Electronics Engineering Previous Question Paper || Download B-Tech 1st Year 1st Sem 13A99101 Basic Electrical and Electronics Engineering Question Paper || JNTU Anantapur B.Tech 1-1 Previous Question Paper || JNTU Anantapur B.Tech ME 1-1 Previous Question Paper || JNTU Anantapur B.Tech CSE 1-1 Previous Question Paper || JNTU Anantapur B.Tech Mech 1-1 Previous Question Paper || JNTU Anantapur B.Tech EEE 1-1 Previous Question Paper || JNTU Anantapur B.Tech ECE 1-1 Previous Question Paper
Code: 13A99101
B.Tech I Year (R13) Supplementary Examinations December 2017
BASIC ELECTRICAL & ELECTRONICS ENGINEERING
(Common to CSE and IT)
Time: 3 hours Max. Marks: 70
Answer all the questions
(Use single answer booklet only)
*****
PART ? A
UNIT ? I
1 Find the equivalent resistance between the terminals AB using Delta-Star transformation for the
circuit shown below:
OR
2 Determine root mean square value, average value, peak factor and form factor for the following
waveform.
UNIT ? II
3 Find the current through resistance using superposition theorem for the circuit shown below:
OR
4 A two part network has the following parameters. Find the parameters and transmission
parameters:
UNIT ? III
5 Explain in detail the principle of operation and characteristics of DC motors.
OR
6 With a neat diagram, explain the construction of 3 ? phase induction motor.
Contd. in page 2
Page 1 of 2
R13
2
3
2.5
1.5 1 0.5
5 V 2A
www.FirstRanker.com www.FirstRanker.com
www.FirstRanker.com
FirstRanker.com - FirstRanker's Choice
www.FirstRanker.com
Code: 13A99101
B.Tech I Year (R13) Supplementary Examinations December 2017
BASIC ELECTRICAL & ELECTRONICS ENGINEERING
(Common to CSE and IT)
Time: 3 hours Max. Marks: 70
Answer all the questions
(Use single answer booklet only)
*****
PART ? A
UNIT ? I
1 Find the equivalent resistance between the terminals AB using Delta-Star transformation for the
circuit shown below:
OR
2 Determine root mean square value, average value, peak factor and form factor for the following
waveform.
UNIT ? II
3 Find the current through resistance using superposition theorem for the circuit shown below:
OR
4 A two part network has the following parameters. Find the parameters and transmission
parameters:
UNIT ? III
5 Explain in detail the principle of operation and characteristics of DC motors.
OR
6 With a neat diagram, explain the construction of 3 ? phase induction motor.
Contd. in page 2
Page 1 of 2
R13
2
3
2.5
1.5 1 0.5
5 V 2A
www.FirstRanker.com www.FirstRanker.com
www.FirstRanker.com
www.FirstRanker.com
Code: 13A99101
PART ? B
UNIT ? I
7 Explain the operation of forward bias and reverse bias PN junction Diode.
OR
8 Explain the operation of section filter with bridge rectifier and also derive an expression for its
stability factor.
UNIT ? II
9 Draw and explain the input and output characteristics of a transistor in CC configuration.
OR
10 Describe the kind of operation that takes place in the enhancement mode MOSFET. How does this
differ from depletion mode type?
UNIT ? III
11 Explain the working of Colpitts oscillator and derive an expression for frequency of oscillation for
Colpitts oscillator.
OR
12 Give the characteristics of an ideal Op-Amp.
*****
Page 2 of 2
R13
www.FirstRanker.com www.FirstRanker.com
www.FirstRanker.com
FirstRanker.com - FirstRanker's Choice
This post was last modified on 11 September 2020