Download PTU (I.K.Gujral Punjab Technical University (IKGPTU)) B-Tech (Bachelor of Technology) (ECE)-Electronics And Communications Engineering 2020 December 4th Sem 57593 Analog Communication Systems Previous Question Paper
Roll No.
Total No. of Pages : 02
Total No. of Questions : 18
B.Tech. (ECE/Electronics Engg) (2012 to 2017) (Sem.?4)
ANALOG COMMUNICATION SYSTEMS
Subject Code : BTEC-401
M.Code : 57593
Time : 3 Hrs. Max. Marks : 60
INST RUCT IONS T O CANDIDAT ES :
1 .
SECT ION-A is COMPULSORY cons is ting of TEN questions carrying TWO marks
each.
2 .
SECT ION-B c ontains F IVE questions c arrying FIVE marks eac h and s tud ents
have to atte mpt any FOUR q ues tions.
3 .
SECT ION-C contains THREE questions carrying T EN marks e ach and s tudents
have to atte mpt any T WO questio ns.
SECTION-A
Answer briefly :
1.
Derive the formula of total Current in AM system.
2.
Draw Frequency spectrum of AM modulated wave and label it properly.
3.
Define the term Frequency Deviation and percent modulation in FM wave.
4.
What is FM capture effect?
5.
Write the basic difference between high level and low level AM modulation.
6.
What is vestigial side band modulation?
7.
What do you mean by tracking and alignment in superheterodyne receiver?
8.
What is pulse position modulation?
9.
What is the need of pre-emphasis and de-emphasis circuits in FM?
10. Define Energy and power of a signal.
1 | M-57593
(S2)-621
SECTION-B
11.
Define the terms Noise figure and Noise equivalent temperature and determine the
receiver noise figure in dB and its equivalent noise temperature. Receiver is connected to
antenna whose resistance is 50. The equivalent noise resistance of the receiver is 30.
12.
Explain Armstrong method of FM generation.
13.
Draw basic circuit of square law diode detector and explain it with characteristics.
14.
Give comparison of SSB transmission and conventional AM.
15.
How PWM and PPM signals are generated in pulse modulation transmission.
SECTION-C
16.
Give comparison of PAM, PPM and PWM pulse modulation techniques.
17.
How many side bands are there in FM, draw its spectrum? If FM wave is given by the
equation s(t) = 20sin(6 * 10108t + 7sin1250t), determine carrier frequency, modulating
frequency, modulation index, maximum deviation and power dissipated by this FM wave
in 100 resistor.
18.
Explain the following :
a. Filter method of single side band generation.
b. Image frequency rejection.
NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any
page of Answer Sheet will lead to UMC against the Student.
2 | M-57593
(S2)-621
This post was last modified on 13 February 2021