This download link is referred from the post: PTU B.Tech Question Papers 2020 December (All Branches)
Roll No. : HHHHHH | Total No. of Pages : 02
Total No. of Questions : 18
--- Content provided by FirstRanker.com ---
B.Tech. (Automation & Robotics) (2018 Batch) (Sem.-3)FLUID MECHANICS AND FLUID MACHINES
Subject Code : BTAR-304-18
M.Code : 76503
Time : 3 Hrs. Max. Marks : 60
--- Content provided by FirstRanker.com ---
INSTRUCTIONS TO CANDIDATES :
- SECTION-A is COMPULSORY consisting of TEN questions carrying TWO marks each.
- SECTION-B contains FIVE questions carrying FIVE marks each and students have to attempt any FOUR questions.
- SECTION-C contains THREE questions carrying TEN marks each and students have to attempt any TWO questions.
SECTION-A
--- Content provided by FirstRanker.com ---
Write briefly :
- Define Specific Gravity.
- Define Surface Tension and write its units.
- State Bernoulli’s equation.
- What is the difference between laminar and turbulent flow?
- What are the advantages of model testing?
- What is cavitation in pumps?
- Define Mechanical Efficiency in turbine.
- State various losses in pipes.
- State the function of draft tube in turbines.
- What is negative slip in reciprocating pump?
--- Content provided by FirstRanker.com ---
--- Content provided by FirstRanker.com ---
SECTION-B
- The water is flowing through a tapering pipe having diameter 300mm and 150 mm at sections 1 and 2 respectively. The discharge through the pipe is 40 litre/sec. The section 1 is 10m above datum and section 2 is 6m above datum. If pressure at section 1 is 400kN/m², find pressure at section 2.
- Differentiate between Francis turbine and Kaplan turbine.
- Discuss Buckingham’s pi theorem for solving dimensional analysis problem.
- A Pelton wheel is receiving water from a penstock with a gross head of 510 m. One-third of gross head is lost in friction in the penstock. The rate of flow through the nozzle fitted at the end of the penstock is 2.2 m³/s. The angle of deflection of the jet is 165 degree. Determine the power given by water to runner by assuming speed ratio 0.45 and coefficient of velocity 1.
- Derive an expression for specific speed of turbine.
--- Content provided by FirstRanker.com ---
SECTION-C
- A liquid of viscosity 0.9 poise is filled between two horizontal plates 10 mm apart. If the upper plate is moving at 1m/s with respect to the lower plate which is stationary and the pressure difference between two sections 60 m apart is 60 kN/m², determine:
a) The velocity distribution--- Content provided by FirstRanker.com ---
b) The discharge per unit width
c) The shear stress on the upper plate. - Discuss in detail main characteristic and operating characteristic curves of centrifugal pump.
- Discuss in detail with diagram the working of single acting reciprocating pump.
NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any page of Answer Sheet will lead to UMC against the Student.
--- Content provided by FirstRanker.com ---
This download link is referred from the post: PTU B.Tech Question Papers 2020 December (All Branches)
--- Content provided by FirstRanker.com ---