FirstRanker Logo

FirstRanker.com - FirstRanker's Choice is a hub of Question Papers & Study Materials for B-Tech, B.E, M-Tech, MCA, M.Sc, MBBS, BDS, MBA, B.Sc, Degree, B.Sc Nursing, B-Pharmacy, D-Pharmacy, MD, Medical, Dental, Engineering students. All services of FirstRanker.com are FREE

📱

Get the MBBS Question Bank Android App

Access previous years' papers, solved question papers, notes, and more on the go!

Install From Play Store

Download PTU M.Tech. EE 1st Semester 36001 ADVANCED POWER ELECTRONICS Question Paper

Download PTU. I.K. Gujral Punjab Technical University (IKGPTU) M.Tech. EE 1st Semester 36001 ADVANCED POWER ELECTRONICS Question Paper.

This post was last modified on 13 December 2019

PTU M.Tech 1st Semester Last 10 Years 2010-2020 Previous Question Papers|| Punjab Technical University


Roll No.

Total No. of Pages : 02

Total No. of Questions : 08

--- Content provided by​ FirstRanker.com ---

M.Tech.(EE)/(Pow System) (Sem.-1)

ADVANCED POWER ELECTRONICS

Subject Code : ELE-503/PEE-503

M.Code: 36001

Time: 3 Hrs.

--- Content provided by​ FirstRanker.com ---

Max. Marks : 100

INSTRUCTION TO CANDIDATES:

  1. Attempt any FIVE questions out of EIGHT questions.
  2. Each question carries TWENTY marks.

Q1. a) Explain reverse recovery characteristics of diode. Hence, draw their characteristics curves.

--- Content provided by​ FirstRanker.com ---

b) Why simultaneous firing of thyristor is required? Explain.

Q2. a) What are applications of series parallel connections of diodes? Illustrate with examples.

b) Compare the characteristics of thyristor, UJT, PUJT and DIAC.

Q3. a) Compare the applications of BJT, MOSFET, SIT IGBT based on their operating characteristics.

b) A thyristor has a junction capacitance of 50 PF. The charging current is limited to 20 mA. What is the value of dv/dt ? If this is to be limited to 250 V/µs .Determine the value of capacitance to be connected across the thyristor ?

--- Content provided by⁠ FirstRanker.com ---

Q4. a) Write the principle of phase control converters. Draw and explain behaviour of three phase full wave cycloconverter.

b) What are reasons for poor power factor in converter? Explain method for overcoming it.

Q5. a) Classify choppers. Design a chopper circuit for DC Shunt motor speed control.

b) Draw and explain the operation of a three phase dual converter. Draw its wave forms also.

Q6. a) What are performance parameter of PWM inverters? Explain in brief.

--- Content provided by​ FirstRanker.com ---

b) A three phase fully controlled bridge converter is feeding a load drawing a constant and ripple free load current of 10A at a firing angle of 30°. Determine the approximate Total Harmonic Distortion (%THD) and the terms value of fundamental component of the input current.

Q7. a) What are Boost and Buck converter? Where are they preferred?

b) Write the principle of PWM Control technique of voltage.

Q8. Write Short notes on :

  1. AC Voltage regulator
  2. --- Content provided by FirstRanker.com ---

  3. Harmonic reduction
  4. Bridge inverter
  5. Chopper

NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any page of Answer Sheet will lead to UMC against the Student.

Visit FirstRanker.com for more question papers.

--- Content provided by​ FirstRanker.com ---



This download link is referred from the post: PTU M.Tech 1st Semester Last 10 Years 2010-2020 Previous Question Papers|| Punjab Technical University

--- Content provided by⁠ FirstRanker.com ---