GUJARAT TECHNOLOGICAL UNIVERSITY
BE - SEMESTER- IV (New) EXAMINATION - WINTER 2019
--- Content provided by FirstRanker.com ---
Subject Code: 2142603 Date: 16/12/2019Subject Name: Rubber engineering
Time: 10:30 AM TO 01:00 PM Total Marks: 70
Instructions:
- Attempt all questions.
- Make suitable assumptions wherever necessary.
- Figures to the right indicate full marks.
--- Content provided by FirstRanker.com ---
MARKS
Q.1 (a) Draw various configurations of three roll calendar. 03
(b) List out any two operations carried out by calendar. 04
--- Content provided by FirstRanker.com ---
(c) What do you mean by frictioning? Discuss the frictioning operation with respect to calender. 07
Q.2 (a) What do you mean by Mixing? Write down any two applications of Farrel Continuous Mixer (FCM). 03
(b) Write down the limitations of Transfer Mix. 04
(c) List out the operating variables for internal mixer. Discuss any three in detail. 07
OR
--- Content provided by FirstRanker.com ---
(c) Compare single geared mixing mill with double geared mixing mill. 07
Q.3 (a) What do you mean by buffing? How is it carried out? 03
(b) Write a short note on kneader. 04
(c) Explain ‘Fish Tail Head’ of extruder. 07
OR
--- Content provided by FirstRanker.com ---
Q.3 (a) Write a brief note on extruder as a strainer. 03
(b) Define the following terms: (i) Die (ii) Head (iii) L/D Ratio (iv) Compression Ratio 04
(c) Write a short note on Vacuum Extruder. 07
Q.4 (a) What do you mean by ‘pebbling’ in terms of moulding? Write their cause and remedy. 03
(b) Short note on ‘mould releasing agents’. 04
--- Content provided by FirstRanker.com ---
(c) Explain the classification of mould according to their operations. 07
OR
Q.4 (a) Define the terms: (i) Cavity (ii) Sprue bush (iii) Runner. 03
(b) Explain the reasons and remedies for air trap. 04
(c) Explain the reasons and remedies for under cure. 07
--- Content provided by FirstRanker.com ---
Q.5 (a) Write down the causes and remedies of sponging. 03
(b) Explain the working of reciprocating type injection unit. 04
(c) Write a short note on Bag-O-Matic press. 07
OR
Q.5 (a) Consistent part quality is difficult to achieve in case of transfer moulding- why? 03
--- Content provided by FirstRanker.com ---
(b) Give the advantages of injection moudling process. 04
(c) Write a short note on planetary mixer. 07
--- Content provided by FirstRanker.com ---
This download link is referred from the post: GTU BE/B.Tech 2019 Winter Question Papers || Gujarat Technological University