GUJARAT TECHNOLOGICAL UNIVERSITY
BE - SEMESTER- VIII (New) EXAMINATION — WINTER 2019
--- Content provided by FirstRanker.com ---
Subject Code: 2182907 Date: 25/11/2019Subject Name: Process & Quality Control in Spinning
Time: 02:30 PM TO 05:00 PM Total Marks: 70
Instructions:
1. Attempt all questions.
--- Content provided by FirstRanker.com ---
2. Make suitable assumptions wherever necessary.3. Figures to the right indicate full marks.
MARKS
Q.1 (a) State the need for process control in spinning? 03
(b) What is yarn realization? 04
--- Content provided by FirstRanker.com ---
(c) Discuss in detail about the machine audit. 07 Q.2 (a) What is Productivity Index (PI)? 03
(b) Discuss briefly about bale management. 04
(c) Write a short note on yarn faults. 07
OR
--- Content provided by FirstRanker.com ---
(c) Explain how the implementation of process control is carried out in cotton 07spinning.
Q.3 (a) What are the key variables for process control in spinning? 03
(b) The quality of mixing affects the cost. Explain. 04
(c) Discuss how the yarn realization of a mill is judged. 07
--- Content provided by FirstRanker.com ---
OR
Q.3 (a) Write briefly about the determination of trash content and cleaning 03
efficiency.
(b) How is performance of blow room assessed? 04
(c) Discuss the measures to control the quality of mixing and hence the cost. 07
--- Content provided by FirstRanker.com ---
Q.4 (a) How can machine efficiency in ring spinning be maximized? 03
(b) Write briefly about optimizing cleaning at cards. 04
(c) Discuss the technological considerations with reference to control of 07
comber waste.
OR
--- Content provided by FirstRanker.com ---
Q.4 (a) Write briefly about control of variability of lea strength. 03(b) Which are the different types of yarn irregularity? 04
(c) Discuss in detail about reducing within bobbin count variation. 07
Q.5 (a) What is RKm of single thread? 03
(b) Write briefly about the high volume instrumentation. 04
--- Content provided by FirstRanker.com ---
(c) Discuss the factors affecting yarn strength. 07 OR
Q.5 (a) State the causes of thick and thin places. 03
(b) Write briefly about package defects. 04
(c) Discuss the use of modern instruments in process control. 07
--- Content provided by FirstRanker.com ---
This download link is referred from the post: GTU BE/B.Tech 2019 Winter Question Papers || Gujarat Technological University
--- Content provided by FirstRanker.com ---