FirstRanker.com
Firstranker's choice
Seat No.: Enrolment No.
--- Content provided by FirstRanker.com ---
GUJARAT TECHNOLOGICAL UNIVERSITY
BE - SEMESTER-IV(NEW) - EXAMINATION - SUMMER 2019
Subject Code:2142606 Date:15/05/2019
Subject Name: Viscoelasticity of Elastomers
Time:02:30 PM TO 05:00 PM Total Marks: 70
--- Content provided by FirstRanker.com ---
Instructions:
- Attempt all questions.
- Make suitable assumptions wherever necessary.
- Figures to the right indicate full marks.
Q.1 (a) Derive the equation for the entropy generated force in polymer chain. 03
--- Content provided by FirstRanker.com ---
(b) Give the difference between Viscosity and Apparent Viscosity. 04(c) Explain in detail about the Bulk modulus with Suitable Example. 07
Q.2 (a) Write about the Deborah number. 03
(b) Give the difference between Dynamic viscosity and Kinematic viscosity 04
(c) Explain the Capillary viscometer in detail. 07
--- Content provided by FirstRanker.com ---
OR
(c) Explain the “Theory of Viscosity”. 07
Q.3 (a) List the molecular requirements of Elastomers. 03
(b) Give the comparison of Time dependent & Time independent non Newtonian fluid. 04
(c) Discuss in detail about the “Viscoplastic fluids.” 07
--- Content provided by FirstRanker.com ---
OR
Q.3 (a) What is the difference between Pseudoplastic and Dilatant fluid? 03
(b) List out the classification of fluids and explain any one in brief. 04
(c) Explain in detail about the Thixotropic and Rheopectic fluids in detail. 07
Q.4 (a) Give the advantages of Voight Model. 03
--- Content provided by FirstRanker.com ---
(b) Write a brief not on Superposition Principles. 04(c) Discuss the Four parameter model in detail. 07
OR
Q.4 (a) Derive the creep experiment equation for Maxwell model. 03
(b) Give the difference between Stress Relaxation and Retardation. 04
--- Content provided by FirstRanker.com ---
(c) A bar of polypropylene is of length 200 mm and has a rectangular cross section 07of diameters 25 mm X 3 mm. It is subjected to a constant tensile load of 250 N acting along its length. 100 s after the load was applied the length is measured and is found to have increased by 0.5 mm. Determine the 100 s tensile creep compliance.
Q.5 (a) Write about the Creep Compliance and Relaxation Modulus. 03
(b) “Bulky Side group affects the Glass transition temperature” justify the statement. 04
(c) Describe the transitions and associated properties with respect to glass transition temperature. P.T.O
--- Content provided by FirstRanker.com ---
OR
Q.5 (a) How the elastic fluids responses under creep test? 03
(b) Write the observation from the phase states of substance and their comparison with the states of aggregates. 04
(c) List out the different factors affecting glass transition temperature explain any two in detail. 07
--- Content provided by FirstRanker.com ---
This download link is referred from the post: GTU BE 2019 Summer Question Papers || Gujarat Technological University
--- Content provided by FirstRanker.com ---