GUJARAT TECHNOLOGICAL UNIVERSITY
BE - SEMESTER-III (New) EXAMINATION - WINTER 2018
--- Content provided by FirstRanker.com ---
Subject Code: 2130902 Date: 01/12/2018
Subject Name: Analog Electronics
Time: 10:30 AM TO 01:00 PM Total Marks: 70
Instructions:
- Attempt all questions.
- Make suitable assumptions wherever necessary.
- Figures to the right indicate full marks.
--- Content provided by FirstRanker.com ---
MARKS
Q.1
(a) Why is the effect of negative feedback on bandwidth? 03
--- Content provided by FirstRanker.com ---
(b) Classify power amplifiers. Write note on Class AB push pull amplifier. 04
(c) Draw and explain biasing circuits for JFET. 07
Q.2
(a) Define following terms. (1) CMRR (2) PSRR (3) Slew Rate 03
(b) Distinguish between Ideal and Practical OP-AMP. 04
--- Content provided by FirstRanker.com ---
(c) Draw and explain block diagram of a typical OP-AMP. 07
OR
(c) Draw the circuit of basic integrator using OP-AMP. What are the problems associated with this configuration? How they are overcome? 07
Q.3
(a) Define following parameter of an OP-AMP, 03
--- Content provided by FirstRanker.com ---
(1) Input bias current (2) Input offset current.
(b) How OP-AMP can be used as a difference amplifier? 04
(c) Derive an expression of voltage gain for closed loop non-inverting OP-AMP. 07
OR
Q.3
--- Content provided by FirstRanker.com ---
(a) How OP-AMP can be used as a peak detector.? 03
(b) Discuss the requirement of instrumentation amplifier along with its applications. 04
(c) Draw the circuit diagram to generate triangular waveform using OP-AMP. 07
Q.4
(a) Explain application of OP-AMP as'a zero crossing detector. 03
--- Content provided by FirstRanker.com ---
(b) Explain the working of RC Phase shift oscillator using OP-AMP. 04
(c) Explain the working of monostable multivibrator using IC-555. 07
OR
Q.4
(a) Explain advantages and application of OP-AMP based Wien bridge oscillator. 03
--- Content provided by FirstRanker.com ---
(b) Explain voltage to current converter circuit using OP-AMP. 04
(c) Explain the operation of voltage controlled oscillator using functional block diagram. 07
Q.5
(a) Write merits of active filters over passive filters. 03
(b) Draw the frequency response of first order butterworth high pass filters. 04
--- Content provided by FirstRanker.com ---
(c) Explain operation of PLL with basic blocks. 07
OR
Q.5
(a) What are the basic design consideration for designing regulated power supplies? 03
(b) Draw and explain block diagram of LM-337 along with its applications. 04
--- Content provided by FirstRanker.com ---
(c) Draw and explain circuit diagram of first order butterworth low pass filter using OP-AMP. 07
--- Content provided by FirstRanker.com ---
This download link is referred from the post: GTU BE/B.Tech 2018 Winter Question Papers || Gujarat Technological University