GUJARAT TECHNOLOGICAL UNIVERSITY
BE - SEMESTER-VIII (NEW) EXAMINATION — WINTER 2017
--- Content provided by FirstRanker.com ---
Subject Code: 2181704Subject Name: Project Engineering and Management
Date: 02/11/2017
Time: 02:30 PM TO 05:00 PM
Total Marks: 70
--- Content provided by FirstRanker.com ---
Instructions:
1. Attempt all questions.
2. Make suitable assumptions wherever necessary.
3. Figures to the right indicate full marks.
MARKS
--- Content provided by FirstRanker.com ---
Q.1 (a) Enlist various types of project engineering documents. 03
(b) Explain mechanical flow sheets and process flow sheets with diagrams. 04
(c) Explain various types of projects and contracts in details. 07
Q.2 (a) Describe importance of project management 03
(b) Explain EPC and BOOT types of projects. 04
--- Content provided by FirstRanker.com ---
(c) What is importance of S curve? Compare CPM vs PERT technique. 07OR
(c) Explain term: Project breakdown structure and planning cycle, project specification, Bar charts related to project management. 07
Q.3 (a) Describe various types of project management functions 03
(b) Explain project controlling and project planning, scheduling in details. 04
--- Content provided by FirstRanker.com ---
(c) Describe various types of project management functions and explain project controlling and project planning, scheduling in details. 07OR
Q.3 (a) Explain significance of wiring and tagging 03
(b) Compare electronic and pneumatic system with various points. 04
(c) Describe various types of control valve with its application. 07
--- Content provided by FirstRanker.com ---
Q.4 (a) Explain various types of orifice plates. 03
(b) Write short note on electronic and pneumatic wiring diagram. 04
(c) Enlist types of level instruments and describe its selection process. 07
OR
Q.4 (a) What is need of calibration in process industry? 03
--- Content provided by FirstRanker.com ---
(b) Explain temp. Transmitter loop checking process. 04(c) Write short note about various types of pressure measurement instrument. 07
Q.5 (a) Enlist various types of flow instrument and narrate its selecting methods. 03
(b) Define control valve coefficient. 04
(c) Write short note on control valve selection 07
--- Content provided by FirstRanker.com ---
OR
Q.5 (a) What is the reason to use 4 to 20 mA standard? 03
(b) Explain single seat, multi seat, split rang, valve range ability related to control valve. 04
(c) Describe various types of standard and explain ISO 9000 test and calibration standard. 07
--- Content provided by FirstRanker.com ---
This download link is referred from the post: GTU BE/B.Tech 2017 Winter Question Papers || Gujarat Technological University
--- Content provided by FirstRanker.com ---