Download PTU B.Tech 2020 March EE 7th and 8th Sem Virtual Instrumentation Question Paper

FirstRanker.com

Roll No. ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ ‘ Total No. of Pages : 02

Total No. of Questions : 09

--- Content provided by‌ FirstRanker.com ---

B.Tech.(EE) (2012 Onwards E-lll) (Sem.-7,8)

B.Tech.(Electrical & Electronics) (2012 Batch E-IIl)

VIRTUAL INSTRUMENTATION

Subject Code : BTEE-805C

M.Code : 71944

--- Content provided by‍ FirstRanker.com ---

Time : 3 Hrs. Max. Marks : 60

INSTRUCTION TO CANDIDATES :

1. SECTION-A is COMPULSORY consisting of TEN questions carrying TWO marks each.
2. SECTION-B contains FIVE questions carrying FIVE marks each and students has to attempt any FOUR questions.
3. SECTION-C contains THREE questions carrying TEN marks each and students has to attempt any TWO questions.

--- Content provided by‌ FirstRanker.com ---

SECTION-A

1. Write briefly :
   1. Why Sub VIs form important part of Virtual Instrumentation and how are they saved?
   2. What are controls and indicators in a VI?
   3. What are the major components of PC based data acquisition system?
   4. What is the use of waveform generator for real time control processes in VI?

   --- Content provided by‌ FirstRanker.com ---

   5. What are the common applications of strings?
   6. Is signal conditioning needed while dealing with signals in VI? Justify.
   7. What is polymorphism in a VI?
   8. What is the use of shift registers in a VI?
   9. What is hard ware triggering in a DAQ system of VI?

   --- Content provided by‍ FirstRanker.com ---

   10. What is the use of clusters in VI?

SECTION-B

2. Write short notes on :
   1. PXI
   2. SCXI

   --- Content provided by⁠ FirstRanker.com ---

3. Create a VI to find determinant of a 2x2matrix.
4. Explain the use of following tabs of devices and interfaces for configuring a DAQ device
   1. System
   2. Base /0O Address
   3. DMA

   --- Content provided by‌ FirstRanker.com ---

5. Build a VI that uses formula node to calculate the following equations:

   Yi=x+x+5

   Y2 = (m*x)+b

6. Explain with a suitable example how parallel loops are controlled in Lab VIEW?

--- Content provided by‍ FirstRanker.com ---

SECTION-C

7. Explain how serial communication is achieved in VI?
8. How analog input devices are configured for specified set of channels with DAQ in VL. Explain by considering Al read and Al start.
9. Create a VI to read a temperature data from a thermocouple by creating a look up table of voltages and temperature equivalent.

NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any page of Answer Sheet will lead to UMC against the Student.

--- Content provided by⁠ FirstRanker.com ---