Firstranker's choice
Total No. of Pages : 02
--- Content provided by FirstRanker.com ---
Roll No.
Total No. of Questions : 10
B.Pharma (2011 to 2016) (Sem.-4)
PHARMACEUTICS IV
(Unit Operation-II)
--- Content provided by FirstRanker.com ---
Subject Code : BPHM-401
Paper ID : [D1140]
Time: 3 Hrs.
Max. Marks : 80
INSTRUCTIONS TO CANDIDATES :
--- Content provided by FirstRanker.com ---
- SECTION-A is COMPULSORY consisting of FIFTEEN questions carrying TWO marks each.
- SECTION-B contains FIVE questions carrying FIVE marks each and students have to attempt any FOUR questions.
- SECTION-C contains FOUR questions carrying TEN marks each and students have to attempt any THREE questions.
SECTION-A
Q1. Define :
--- Content provided by FirstRanker.com ---
- Mole fraction
- Size reduction
- Unit operations
- Viscosity
- Raoult's law
- Distillation
- Distillation
- CMC
- Heat transfer
- Volatility
--- Content provided by FirstRanker.com ---
--- Content provided by FirstRanker.com ---
Distinguish between :
- Freeze drying and vacuum drying
- positive deviation vs negative deviation from Raoult's law
- Ball mill and Hammer mill
- Single and multiple effect evaporators
- Colloidal mill and fluid energy mill.
--- Content provided by FirstRanker.com ---
SECTION-B
Q2. A tube 0.09 in. OD is lagged with 0.02 in. layer of asbestose with a conductivity of 0.10 Btu/hr. ft² °F followed 0.06 in. layer of cork whose conductivity is 0.06 Btu/hr. ft² °F. If the temperature difference between inner and outer surface is 1400 °F, Calculate heat loss.
Q3. Classify evaporators? What are the factors effecting evaporation.
Q4. Explain the deviations from Raoult's law with examples.
--- Content provided by FirstRanker.com ---
Q5. Highlight the mechanisms of drying. Brief principle of vacuum drying.
Q6. Explain the principles of size Reduction.
Q7. Explain the principle, construction and working of hammer mill.
Q8. How could you calculate the number of theoretical plates needed for a distillation process?
Q9. Discuss the role of size separation in a size reduction process. Give principle and working of fluid energy mill.
--- Content provided by FirstRanker.com ---
Q10. Comment on the following :
- In spray drying, the temperature at which the sprayed droplet dries is much lower than the temperature of the gas used for drying.
- Size reduction in ball mill is by impact only
- Steam distillation occurs at 100°C.
NOTE : Disclosure of Identity by writing Mobile No. or Marking of passing request on any paper of Answer Sheet will lead to UMC against the Student.
--- Content provided by FirstRanker.com ---
This download link is referred from the post: PTU B.Pharma 4th Semester Last 10 Years 2011-2021 Previous Question Papers|| Punjab Technical University