Download PTU B-Tech AE 2020 Dec 3rd Sem 54109 Mechanics Of Materials Question Paper

FirstRanker.com
Firstranker's choice

www.FirstRanker.com

--- Content provided by‌ FirstRanker.com ---

Roll No. Total No. of Pages : 02
Total No. of Questions : 18

B.Tech. (AE) (2012 to 2017) (Sem.-3)
MECHANICS OF MATERIALS
Subject Code : BTAE-301

--- Content provided by​ FirstRanker.com ---

INSTRUCTIONS TO CANDIDATES :

1. SECTION-A is COMPULSORY consisting of TEN questions carrying TWO marks each.
2. SECTION-B contains FIVE questions carrying FIVE marks each and students have to attempt any FOUR questions.

--- Content provided by​ FirstRanker.com ---

3. SECTION-C contains THREE questions carrying TEN marks each and students have to attempt any TWO questions.

SECTION-A

Write briefly :

1. Define the term stress. What are different types of stresses?
2. What is the use of stress-strain diagram?

--- Content provided by⁠ FirstRanker.com ---

3. What will be change in modulus of elasticity of a wire when length of wire is doubled, and load is increased by factor of 4?
4. What do you mean by thermal stresses?
5. Define point of contraflexure.
6. What is relationship between shear force and bending moment?
7. Define the term torsional rigidity.

--- Content provided by⁠ FirstRanker.com ---

8. State maximum principle shear-strain theory.
9. Write the limitations of Euler’s theory.
10. What are thick and thin cylinders?

SECTION-B

11. A symmetrical section 200 mm deep has a moment of inertia of 2.26 x 10^-4 m⁴ about its neutral axis. Determine the longest span over which, when simply supported, the beam would carry a uniformly distributed load of 3kN/m run without the stress due to bending exceeding 10 MN/m².

--- Content provided by FirstRanker.com ---

www.FirstRanker.com

12. Find the value of P necessary for equilibrium, if E = 210 kN/mm². Also determine the elongation of the bar.

FIG.1

13. Draw the SFD and BMD for the beam shown below.

--- Content provided by​ FirstRanker.com ---

FIG.2

14. Prove that for a rectangular cross-section beam, the maximum shear stress is 1.5 times the average shear stress.
15. Stating the assumptions, drive the torsion equation for a circular shaft. Assume suitable parameters.

SECTION-C

--- Content provided by‌ FirstRanker.com ---

16. Derive the Euler’s formula for long columns having both ends hinged or pinned.
17. A boiler shell is to be made of 15mm thick plate having tensile stress of 120 MN/m². If the efficiencies of the longitudinal and circumferential joints are 70% and 30% respectively, determine :
    1. Maximum permissible diameter of the shell for an internal pressure of 2 MN/m².
    2. Permissible intensity of internal pressure when the shell diameter is 1.5 m.
18. A hollow shaft having an inside diameter 60% of its outer diameter is to replace a solid shaft transmitting the same power at same speed. Calculate the percentage saving in material. The material of hollow and solid shaft is same.

--- Content provided by‍ FirstRanker.com ---

NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any page of Answer Sheet will lead to UMC against the Student.

www.FirstRanker.com