GUJARAT TECHNOLOGICAL UNIVERSITY
SEMESTER-IV(NEW) - EXAMINATION - SUMMER 2019
--- Content provided by FirstRanker.com ---
Subject Code:2142905 Date:15/05/2019
Subject Name: Statistical Quality Control & Textile Costing
Time:02:30 PM TO 05:00 PM Total Marks: 70
Instructions:
- Attempt all questions.
- Make suitable assumptions wherever necessary.
- Figures to the right indicate full marks.
--- Content provided by FirstRanker.com ---
MARKS
Q.1 (a) Define the term: 1. Standard Deviation 2. PMD 3. Coefficient of variation 03
(b) Explain significance of control chart. 04
--- Content provided by FirstRanker.com ---
(c) Following are the results of the fabric strength (in 10 gm) obtained from the 07 samples of two different fabrics.
Fabric A | 22.0 | 21.5 | 22.8 | 21.0 | 23.0 | 20.9 | 21.6 | 22.0 | 22.8 | 21.2
Fabric B | 22.3 | 21.6 | 22.0 | 22.1 | 22.0 | 22.3 | 21.8 | 21.8 | 21.6 | 21.8
Find out using above data which fabric is more consistent in terms of the strength.
Q.2 (a) Ten-count tests carried out on the yarn of a cone have shown AM 25.62 and 03 another 15-count tests carried out on the yarn of same cone have shown AM 26.25. what is the AM of the yarn if all 25 tests taken together?
--- Content provided by FirstRanker.com ---
(b) Explain Binomial distribution with their properties. 04
(c) Conduct the analysis of variance (one-way classification) for the following 07 data. State whether the lea count differ between the bobbins.
Lean Bobbin No.
No. 1 2 3 4 5 6
1 22 23 24 21 20 19
--- Content provided by FirstRanker.com ---
2 21 20 22 23 24 19
3 20 19 21 20 22 23
4 18 24 20 19 22 24
Table value of F for 5, 18 d.f.-at 5% level=2.77 & level=4.25
OR
--- Content provided by FirstRanker.com ---
(c) An experiment was conducted to study the effect of the speed of the ring 07 frame on the count of the yarn. The yarn was spun with four different speeds on three different ring frames and the results yarn counts are follows.
Speed (RPM)
15000 16000 17000 18000
Ring 1 85 88 85 90
Frame 11 70 85 90 95
--- Content provided by FirstRanker.com ---
11 80 82 88 92
Carry out analysis of the above data and write the conclusions.
(Table value of F for 3, 6 degree of freedom at 5% level = 4.76)
(Table value of F for 2, 6 degree of freedom at 5% level = 5.14)
Q.3 (a) What is correlation? Explain positive and negative correlation. 03
--- Content provided by FirstRanker.com ---
(b) Find out Quartile deviation of the following data and its relative measure. 04
Value 10 15 20 25 30 35 40
Frequency 5 10 16 20 14 8 4
(c) Compute karl pearson’s coefficient of correlation from following data of 07 percentage humidity and warp breakages were recorded from a weaving factory and comment on it.
Warp 112 | 110 | 120 | 102 | 122 | 118 | 90
--- Content provided by FirstRanker.com ---
Breakages
50 90 60 70 67 62 65 80
OR
(a) Explain Poisson distribution with their properties. 03
(b) State the properties of Normal distribution. 04
--- Content provided by FirstRanker.com ---
(c) Following are the marks obtained by eight different students in the subjects 07 of mathematics and the subject of statistics.
Student no. 1 2 3 4 5 6 7 8
Marks in Mathematics 50 52 68 70 72 70 63 75
Marks in statistics 50 90 60 70 67 62 65 80
Calculate rank correlation coefficient using the above data and comment on it.
--- Content provided by FirstRanker.com ---
Q.4 (a) Briefly explain about the small sample t-test. 03
(b) Five knitted garments each were selected at eight different times during the 04 production and following results of number of defective garments were obtained.
Sample nos. 1 2 3 4 5 6 7 8
No. of defective garments 0 2 1 1 2 0 0 0
Draw the np-chart for the above data.
--- Content provided by FirstRanker.com ---
(c) Ten ring bobbins selected from the production of the day shift and fifteen 07 ring bobbins selected from the production of the night shift have shown following results.
Day shift Night shift
No. of tests 10 15
Average count 40.2 39.3
Std. dev. of count 2.5 3.8
--- Content provided by FirstRanker.com ---
From these sample results, is there any evidence that the yarn spun during night shift is coarser than the day shift? Use 10% los. (Table value t23,01=1.319)
OR
(a) Explain about collection and types of data. 03
(b) Following data represents average and range of linear density of the yarn 04 obtained from eight different samples each size five, selected during a spinning process.
Sample nos. 1 2 3 4 5 6 7 8
--- Content provided by FirstRanker.com ---
Avg. Linear density | 19.6 | 20.1 | 20.5 | 19.4 | 22.3 | 21.7 | 20.3 | 19.9
Range 12 12 11 16 18 20 17 20 18
Draw the mean charts for the above data.(A=0.577)
(c) The following data are related to the percentage of humidity and the warp 07 breakage rate recorded for a week in a loom shed.
% Humidity 54 | 85 | 86 | 50 | 42 | 75 | 65 | 56
--- Content provided by FirstRanker.com ---
Warp breakage rate 2.45 | 1.12 | 1.20 | 2.84 | 3.25 | 1.86 | 1.90 | 2.32
Using equation of line of regression, find warp breakage rate if humidity percentage on a specific day is 60 for given data.
Q.5 (a) Find out median from the following data. 03
Class 0-10 10-20 20-30 30-40 40-50
Frequency 18 30 46 34 22
--- Content provided by FirstRanker.com ---
(b) Discuss about population and sample. 04
(c) Explain in detail about DMAIC process. 07
(a) Write short note on Material cost. 03
(b) Write short note on labour cost. 04
(c) A spinning mill is working with following mix: 07
--- Content provided by FirstRanker.com ---
Cotton Variety Proportion (%) Cost/Kg. (in Rs.)
P1 10 4
P2 20 5
P3 30 6
P4 40 7
--- Content provided by FirstRanker.com ---
Calculate clean cotton cost/kg. If yarn realization is 88% & that out of the 25 kg lost per 100kg. put through, 8 kg. are saleable at 1.75 Rs./kg.
--- Content provided by FirstRanker.com ---
This download link is referred from the post: GTU BE 2019 Summer Question Papers || Gujarat Technological University