GUJARAT TECHNOLOGICAL UNIVERSITY
SEMESTER-IV(OLD) - EXAMINATION - SUMMER 2019
--- Content provided by FirstRanker.com ---
Subject Code: 141901 Date: 17/05/2019
Subject Name: Mechanical Measurement & Metrology
Time: 02:30 PM TO 05:00 PM Total Marks: 70
Instructions:
- Attempt all questions.
- Make suitable assumptions wherever necessary.
- Figures to the right indicate full marks.
--- Content provided by FirstRanker.com ---
Q.1 (a) Define and Explain following terms: (07)
(i) Accuracy and Precision (ii) Error (iii) Threshold.
Q.1 (b) Explain the construction and use of the Sine bar. (07)
--- Content provided by FirstRanker.com ---
Q.2 (a) Explain construction and working of LVDT. (07)
Q.2 (b) Explain pneumatic comparator and state the advantages and disadvantages. (07)
OR
Q.2 (a) Describe followings with neat sketch. (07)
(i) Slip Gauge (ii) Dial Indicator.
--- Content provided by FirstRanker.com ---
Q.3 (a) Explain three wire method to measure the effective diameter of given screw thread with neat sketch. (07)
Q.3 (b) List and explain characteristics of measuring devices stating illustrations. (07)
OR
Q.3 (a) What are the various possible sources of errors in measurement? Define static error and explain any two static errors with example. (07)
Q.4 (a) Describe with sketch the construction and use of Gear Tooth Vernier Caliper. (07)
--- Content provided by FirstRanker.com ---
Q.4 (b) How is the gear tooth thickness at PCD measured? (07)
Q.4 (a) Explain Surface Texture and Elements of Surface Roughness. (07)
Q.4 (b) Describe construction and working of Optical pyrometer. (07)
OR
--- Content provided by FirstRanker.com ---
Q.4 (a) Define Flatness and describe a method to find out the flatness of a surface plate. (07)
Q.5 (a) Describe the construction and working of resistance temperature detector (RTD) with its advantages and disadvantages. (07)
Q.5 (b) Explain with sketch construction and working of Piezometer & U-Tube Manometer stating application. (07)
Q.5 (a) Explain construction and working of vibrating reed tachometer. (07)
OR
--- Content provided by FirstRanker.com ---
Q.5 (b) Explain briefly the construction and working of bourdon tube pressure gauge. (07)
Q.5 (a) Explain working principle of Stroboscope. And list steps to measure angular speed of shaft using stroboscope. (07)
--- Content provided by FirstRanker.com ---
This download link is referred from the post: GTU BE 2019 Summer Question Papers || Gujarat Technological University