Roll No. Total No. of Pages : 02
Total No. of Questions: 18
--- Content provided by FirstRanker.com ---
B.Tech. (Electrical & Electronics)/(Electronics & Electrical) (Sem.-7)
WIRELESS COMMUNICATION
Subject Code : BTEEE-804F
M.Code : 71968
Time : 3 Hrs. Max. Marks : 60
--- Content provided by FirstRanker.com ---
INSTRUCTIONS TO CANDIDATES :
- SECTION-A is COMPULSORY consisting of TEN questions carrying TWO marks each.
- SECTION-B contains FIVE questions carrying FIVE marks each and students have to attempt any FOUR questions.
- SECTION-C contains THREE questions carrying TEN marks each and students have to attempt any TWO questions.
SECTION-A
--- Content provided by FirstRanker.com ---
Write briefly :
- Calculate channel capacity of TDMA in cell system.
- What is called shadowing?
- What are the limitations of 1G cellular network?
- Write the drawback of Bit-Error-rate-Driven diversity.
- Compare the capacity of a fading and a non-fading channel for information.
- What are the main transmission technologies for WLAN?
- Discuss the fundamental concepts of all-IP networks.
- What is the frequency of separation between uplink and downlink in AMPS and GSM?
- List the benefits of cellular-WLAN integration architecture.
- Draw the forward link structure in IS-95 CDMA.
--- Content provided by FirstRanker.com ---
--- Content provided by FirstRanker.com ---
SECTION-B
- Explain briefly the following terms used in telephony :
- Busy hour calling rate
- Unit call
- How does multipath fading is mitigated with the design of base station antennas? Explain.
- Write short notes on support of mobility on the Internet.
- A group of N stations share 100 Kbps slotted ALOHA channel. Each station output a 500 bits frame on an average of 5000ms even if previous one has not been sent. What is the required value of N?
- Describe the functions of the MS and SIM. Why does GSM separate the MS and SIM?
--- Content provided by FirstRanker.com ---
SECTION-C
--- Content provided by FirstRanker.com ---
- What signalling facilities are to be provided by subscriber's instrument in an automatic telephone exchange? Explain in detail. Also show how this is achieved by a schematic diagram?
- What is difference between multiplexing and multiple access techniques? Are FDM and TDM similar to corresponding FDMA/TDMA respectively? If not, why? Explain the relative advantages and disadvantages of FDM A and TDMA.
- Draw the IEEE 802.11 protocol architecture, name the main elements and describe their functions. Why is the PHY layer in IEEE 802.11 subdivided?
NOTE: Disclosure of Identity by writing Mobile No. or Making of passing request on any page of Answer Sheet will lead to UMC against the Student.
--- Content provided by FirstRanker.com ---
This download link is referred from the post: PTU B.Tech 2021 January Previous Question Papers || PTU Punjab Technical University
--- Content provided by FirstRanker.com ---