This download link is referred from the post: AKTU B-Tech Last 10 Years 2010-2020 Previous Question Papers || Dr. A.P.J. Abdul Kalam Technical University
NEC-409
(Following Paper ID and Roll No. to be filled in your Answer Book)
--- Content provided by FirstRanker.com ---
PAPER ID: 131409
Roll No.
B. Tech.
(SEM. IV) THEORY EXAMINATION, 2014-15
INTRODUCTION TO MICROPROCESSOR
--- Content provided by FirstRanker.com ---
Time: 3 Hours] [Total Marks: 100
-
Attempt any FOUR questions of the following: 4×5=20
- Explain the evolution of microprocessor in brief.
-
Determine the result of A after the execution of the following program:
MVI A, 13H
--- Content provided by FirstRanker.com ---
INR A
XRA A
ADI 41 H
ADD A
- How instruction cycle, machine cycle and clock cycle are related? Explain them with proper sketches?
- Write ALP to load A with 40 H & subtract 29 H from it. Multiply the 'result by 2 & store the result in the Register L.
- Explain the difference between (1) RAM and ROM (2) SIM and RIM.
- Explain the Memory mapped I/O and Peripheral Mapped I/O.
--- Content provided by FirstRanker.com ---
-
Attempt any FOUR questions of the following: 4×5=20
- List the four operations commonly performed by the MPU.
- What is flag? Explain each flag of 8085 microprocessor.
- How many address lines are necessary to address 8 K byte of memory?
- What is function of accumulator?
- What is transparent latch, and why it is necessary to use a latch with output device?
- If the clock frequency is 5 MHZ, how much time is required to execute an instruction of 18-T states?
--- Content provided by FirstRanker.com ---
-
Attempt any two questions of the following : 2×10=20
- Explain the interrupts used in 8085 briefly. What is the difference between 8085 & 8086?
- With a neat diagram describe the internal architecture of 8085. State the function of each block shown.
- What is the difference between Maximum and Minimum mode of operation in 8086?
--- Content provided by FirstRanker.com ---
-
Attempt any TWO questions of the following: 2×10=20
- Discuss the various logic devices used in interfacing circuits.
-
Explain the function of the following instructions :
- SIM
- PUSH
- DAA
- XCHG
- CALL
--- Content provided by FirstRanker.com ---
-
- Draw the timing diagram of the following instruction : ADD B
- CALL 2050 H.
--- Content provided by FirstRanker.com ---
--- Content provided by FirstRanker.com ---
--- Content provided by FirstRanker.com ---
--- Content provided by FirstRanker.com ---
This download link is referred from the post: AKTU B-Tech Last 10 Years 2010-2020 Previous Question Papers || Dr. A.P.J. Abdul Kalam Technical University