Download VTU B-Tech/B.E 2019 June-July 1st And 2nd Semester 2018 Jan 2017 Dec 17ELN15 Basic Electronics Question Paper

Firstranker's choice

FirstRanker.com

USN 1:7ELN15

--- Content provided by​ FirstRanker.com ---

First Semester B.E. Degree Examination, Dec.2017/Jan.2018

Basic Electronics

Time: 3 hrs. Max. Marks: 100

Note: Answer any FIVE full questions, choosing one full question from each module.

Module-1

--- Content provided by‌ FirstRanker.com ---

1 a. Explain the operation of PN junction diode under forward and reverse biased conditions, with the help of VI characteristics curve. (06 Marks)

b. Derive the relation between a and ß. Calculate Ic and IE for transistor that has adc = 0.98 and IB = 100 µA. (06 Marks)

c. With a neat circuit diagram and waveforms, explain the working of centre-tap full wave rectifier and derive the efficiency for the same. (08 Marks)

OR

2 a. With a neat diagram, explain the operation of PNP and NPN transistor. (08 Marks)

--- Content provided by FirstRanker.com ---

b. A half wave rectifier from a supply 230 V 50 Hz with step down transformer ratio 3:1 to a resistive load of 10 KO. The diode forward resistance is 75 O and transformer secondary is 10 O. Calculate the DC current, DC voltage, efficiency and ripple factor. (06 Marks)

c. With neat circuit diagram, explain the common emitter circuit and sketch the input and output characteristics. (06 Marks)

Module-2

3 a. With a necessary equation and circuit, explain the base-bias transistor circuits. (06 Marks)

b. Design an Adder using op-amp to give the output voltage, V = -(2V₁ +3V₂+5V₃). (06 Marks)

--- Content provided by FirstRanker.com ---

c. Derive the equations for output voltage for an inverting amplifier and an integrator. (08 Marks)

OR

4 a. Explain the characteristics of an ideal op-amp. Mention the applications. (06 Marks)

b. Accurately analyze the voltage divider bias which has Vcc = 18 V, R1 = 33 KO, R2 = 12 KO and RE = 1 KO. Determine VE VC, VCE, IC and Q point, when transistor hfe = 200. (08 Marks)

c. Write short notes on op-amp virtual ground concept. (06 Marks)

--- Content provided by FirstRanker.com ---

Module-3

5 a. Perform the following:

i) Convert (57345)₁₀ — ( )₁₆

ii) Subtract (28)₁₀ — (19)₁₀ using 2's complement method. (06 Marks)

b. Realize Y = AB + CD + E using NAND gate. (06 Marks)

--- Content provided by FirstRanker.com ---

c. Explain the full adder circuit with truth table. Realize the circuit for sum and carry using logic gates. (08 Marks)

FirstRanker.com

OR

6 a Perform the following:

i) Convert (FA27D)₁₆ = ( )₂ = ( )₈ = ( )₁₀

--- Content provided by⁠ FirstRanker.com ---

ii) Subtract 10.0101 — 101.1110 using 1's compliment method. (06 Marks)

b. y = A + AB + ABC simplify and implement using logic gates and NOR gates. (06 Marks)

c. State and prove De Morgan's theorem using two variable. (08 Marks)

Module-4

7 a. Bring out differences between flip flops and latches. (04 Marks)

--- Content provided by FirstRanker.com ---

b. Explain SR flipflop with circuit diagram and truth table. (06 Marks)

c. With a neat block diagram explain the architecture of 8051 microcontroller. (10 Marks)

OR

8 a. Explain the operation of NAND gate latch with circuit and truth table. (10 Marks)

b. What is stepper motor? With a neat block diagram, explain the working principle of microcontroller based stepper motor control system. (10 Marks)

--- Content provided by‌ FirstRanker.com ---

Module-5

9 a. Define communication. With neat block diagram, explain the elements of communication system. (06 Marks)

b. Derive an expression for amplitude modulation and draw the necessary waveforms. (08 Marks)

c. What is transducer? Compare the active and passive transducers. (06 Marks)

10 a. Bring out the difference between amplitude modulation and frequency modulation. (06 Marks)

--- Content provided by​ FirstRanker.com ---

b. If a FM wave represented by the equation sin (8 x 10⁸ + 4sin1000t), calculate:

i) Carrier frequency ii). Modulating frequency

iii) Modulation index iv) Band width (06 Marks)

C. With necessary diagram and equations, explain the following:

i) Piezo-electric transducer (08 Marks)

--- Content provided by FirstRanker.com ---

ii) LVDT.