Subject Code: 3152409
GUJARAT TECHNOLOGICAL UNIVERSITY
--- Content provided by FirstRanker.com ---
BE- SEMESTER-V (NEW) EXAMINATION - WINTER 2020
Date: 29/01/2021
Subject Name: Microcontrollers Architecture, Interfacing and Applications
Time: 10:30 AM TO 12:30 PM
Instructions:
--- Content provided by FirstRanker.com ---
- Attempt any FOUR questions out of EIGHT questions.
- Make suitable assumptions wherever necessary.
- Figures to the right indicate full marks.
Q.1
- Discuss (1) EEPROM (2) DRAM [03]
- Draw the block diagram of microcontroller 8051. [04]
- Why delay are required during programming and how they are generated? [07]
--- Content provided by FirstRanker.com ---
Q.2
- Define bits of SCON & TCON registers. [03]
- Define the terms: address bus, data bus and control bus. [04]
- Explain SFR (Special Function Register) and PSW (Program Status Word). [07]
--- Content provided by FirstRanker.com ---
Q.3
- State important criterion for the selection of microcontroller. [03]
- Explain Instructions: LIMP, XCHD, CJNE, and NOP. [04]
- Write a program to generate an output as a square wave with a frequency of 50 Hz at P2.2 pin of 8051. Assume that the crystal frequency is 12MHz. [07]
--- Content provided by FirstRanker.com ---
Q.4
- Explain TMOD register. [03]
- Define instruction cycle, machine cycle & T-state. [04]
- Write a program to Toggle all the LEDs ON and OFF (Blinking LEDs) with a frequency of 01 Hz that are connected to PORT 01 of the 8051 Microcontroller. Take crystal frequency of 12 Mhz. [07]
Q.5
--- Content provided by FirstRanker.com ---
- What is the function of interrupts in 8051? List various interrupts available in 8051. [03]
- Explain any two logical instructions of 8051 microcontroller. [04]
- Explain different addressing modes of 8051 with example. [07]
Q.6
- What do you mean by stack? Explain in brief w.r.t 8051. [03]
- Write a brief note on DAC. [04]
- Explain interfacing of 7-segment display with 8051 microcontroller. [07]
--- Content provided by FirstRanker.com ---
Q.7
- Explain the Interfacing of LED with 8051. [03]
- State the similarities and differences between following instructions. ADD A, @R1 and ADD A, R1 [04]
- State various types of Jump and Loop instructions. Explain any three with examples. [07]
--- Content provided by FirstRanker.com ---
Q.8
- What is a subroutine in 8051? Explain in brief with a suitable short example. [03]
- Compare vectored & non-vectored interrupts for 8051 microcontroller. [04]
- Draw internal architecture of 8051 microcontroller. Discuss function of each block in detail. [07]
--- Content provided by FirstRanker.com ---
Total Marks: 56
--- Content provided by FirstRanker.com ---
This download link is referred from the post: GTU B.Tech 2020 Winter Question Papers || Gujarat Technological University