PTU Punjab Technical University B-Tech May 2019 Question Papers 6th Semester Automation Robotics ECE-EIE
Total No. of Pages : 02
Total No. of Questions : 09
B.Tech.(Automation & Robotics) (DE-I 2011 & Onward)
B.Tech.(ECE/ ETE) (E-I 2011 Onwards)
(Sem.?6)
DIGITAL SYSTEM DESIGN
Subject Code : BTEC-904
M.Code : 71233
Time : 3 Hrs. Max. Marks : 60
INSTRUCTIONS TO CANDIDATES :
1.
SECTION-A is COMPULSORY consisting of TEN questions carrying T WO marks
each.
2.
SECTION-B contains FIVE questions carrying FIVE marks each and students
have to attempt any FOUR questions.
3.
SECTION-C contains T HREE questions carrying T EN marks each and students
have to attempt any T WO questions.
SECTION-A
1.
Answer briefly :
a) Define the race around condition. How can it be avoided?
b) Covert the JK flip flop into D flip-flop.
c) What is an ASM chart? What are its basic elements?
d) What are the problems associated with a ripple counter?
e) Realize NAND and OR gates using 2:1 MUX.
f) What is a flip flop and how is it different from a latch?
g) Define a Mealy machine.
h) If three mod 16 counters are used in cascade, What will the maximum counting
range?
i) What is the role of a delay element in an asynchronous sequential circuit?
j) What is a transition table and how is it different from a flow table?
1 | M - 7 1 2 3 3
( S 2 ) - 2 3 8 6
SECTION-B
2.
Design a 4 bit BCD adder.
3.
Derive the characteristic equations and the excitation tables for SR, JK, T and D type flip
flops.
4.
Differentiate between PROM, PLA and PAL.
5.
What are the differences between synchronous and asynchronous sequential circuits?
6.
A combinational logic is defined by the function :
F1(A,B,C) = m(3,5,6,7)
F2(A,B,C) = m(0,2,4,7)
Implement the circuit with PLA having three inputs, four product terms and two outputs.
SECTION-C
7.
Design a counter that goes through the states 0, 3, 5, 6, 0,..... using T flip flops (only).
Show how the lock out condition is taken care of.
8.
What are static and dynamic hazards? Implement the circuit for the following function
after removing various hazards.
F(A,B,C) = m (0,1,3,4,6,7)
9.
Design a sequence generator using JK flip flop for the sequence : 1001001.
NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any
page of Answer Sheet will lead to UMC against the Student.
2 | M - 7 1 2 3 3
( S 2 ) - 2 3 8 6
This post was last modified on 04 November 2019