Download GTU (Gujarat Technological University) BE/BTech (Bachelor of Engineering / Bachelor of Technology) 2018 Winter 6th Sem Old 160201 Automobile Component Design Previous Question Paper
1
Seat No.: ________ Enrolment No.___________
GUJARAT TECHNOLOGICAL UNIVERSITY
BE - SEMESTER ?VI (OLD) EXAMINATION ? WINTER 2018
Subject Code:160201 Date: 07/12/2018
Subject Name: Automobile Component Design
Time: 02:30 PM TO 05:00 PM Total Marks: 70
Instructions:
1. Attempt all questions.
2. Make suitable assumptions wherever necessary.
3. Figures to the right indicate full marks.
Q.1 (a) Explain lubrication and mounting of bearing. 07
(b) Explain the theory of Beam strength of gear tooth for spur gear. 07
Q.2 (a) Explain design criteria of intake manifold and exhaust manifold. 07
(b) Describe design of spline shafts for gear box used in automobiles. 07
OR
(b) Write a note on design criteria of connecting rod. 07
Q.3 (a) Explain design of valves in I.C.Engine with sketch. 07
(b) Describe taper rolling bearing and thrust ball bearing with sketch. 07
OR
Q.3 (a) Explain the design of components for casting and welding. 07
(b) Write a note on combustion chamber design in automobile component design. 07
Q.4 (a) The following data is given for the piston of a four stroke diesel engine :
Cylinder bore = 250 mm
Maximum gas pressure = 4 MPa
Allowable bearing pressure for skirt = 0.4 MPa
Ratio of side thrust on liner to maximum gas load on piston = 0.1
Width of top land = 45 mm
Width of ring grooves = 6 mm
Total number of piston rings = 4
Axial thickness of piston rings = 7 mm
Calculate: (1) length of skirt and (2) length of piston.
07
(b) Explain design consideration of gearbox. 07
OR
Q.4 (a) A pair of parallel helical gears consists of a 20 teeth pinion meshing with a 100
teeth gear. The pinion rotates at 720 rpm. Then normal pressure angle is 20
degree, while the helix angle is 25 degree. The face width is 40 mm and the
normal module is 4 mm. The pinion as well as the gear is made of steel 40C8
( Sut = 600N/mm
2
) and heat treated to a surface hardness of 300 BHN. The service
factor and the factor of safety are 1.5 and 2 respectively. Take Lewis factor Y =
0.344 .Assume that the velocity factor accounts for the dynamic load and
calculate the power transmitting capacity of gears.
07
(b) Explain thermal consideration in automobile component design. 07
Q.5 (a) Describe the criteria of design for solid and rim type flywheel. 07
(b) Explain gear terminology for bevel gear with neat sketch. 07
OR
Q.5 (a) Explain beam strength and wear strength of bevel gears. 07
(b) Explain dry liners and wet liners with neat sketch. 07
*************
www.FirstRanker.com www.FirstRanker.com
www.FirstRanker.com
FirstRanker.com - FirstRanker's Choice
This post was last modified on 20 February 2020