Firstranker's choice
Code: 13A02101
--- Content provided by FirstRanker.com ---
B.Tech I Year (R13) Supplementary Examinations December 2019
ELECTRICAL CIRCUITS
(Electrical & Electronics Engineering)
Time: 3 hours
Max. Marks: 70
--- Content provided by FirstRanker.com ---
PART - A
(Compulsory Question)
*****
1 Answer the following: (10 X 02 = 20 Marks)
- Define about Active and Passive elements with examples
- When two branches having (2+j10) and (5+j20)O are connected in parallel and their equivalent is in series with (8+j30)O. Find the total equivalent impedance.
- Describe the importance of power factor.
- For half wave rectified alternating current, find form factor.
- Define and describe briefly about band width.
- Discuss briefly about Super Node with neat sketch.
- Write the statement of compensation theorem.
- Write any two applications of superposition theorem.
- List any two applications of Laplace transforms.
- Describe briefly about Line Spectra.
--- Content provided by FirstRanker.com ---
--- Content provided by FirstRanker.com ---
PART - B
--- Content provided by FirstRanker.com ---
(Answer all five units, 5 X 10 = 50 Marks)
UNIT - I
- (a) Explain in detail about resistance, inductance and capacitance parameters.
(b) An iron ring 10 cm diameter and 15 cm² in cross section is wound with 250 turns of wire of flux density of 1.5 Web/m² and permeability 500. Find the exciting current, the inductance and stored energy. Find corresponding quantities when there is a 2 mm air gap.
OR - (a) Derive the relation between self and mutual inductances. Also, derive the expression for coefficient of coupling between two mutually coupled coils.
(b) Find the power dissipated at 6O resistor in the network shown below.
20V
5 ohms
--- Content provided by FirstRanker.com ---
UNIT - II
--- Content provided by FirstRanker.com ---
- (a) Explain about how to calculate voltage and power in a balanced three phase circuit.
(b) For a half wave rectified alternating current find Average value, RMS value, Form factor and Peak factor. Find the average and RMS values when Im is 3A.
OR - (a) Discuss in detail about unbalanced three phase delta circuits with inductive loads.
(b) Explain about two wattmeter method for measuring three phase power.
--- Content provided by FirstRanker.com ---
Contd. in page 2
Firstranker's choice
Code: 13A02101
--- Content provided by FirstRanker.com ---
UNIT - III
- (a) Draw and explain in detail about the locus diagram for R-L-C series circuit.
(b) Write short notes on Graph, Tree and Link with examples.
OR - (a) In the circuit shown below, determine the power delivered to 4O resistor by mesh analysis.
12V
1O
2O
4O--- Content provided by FirstRanker.com ---
(b) The reduced incidence matrix of a graph is given below. Draw the graph corresponding to it.
[-1 +1 0 0
0 -1 1 0
0 0 -1 +1
0 0 +1 0 -1 +1]
--- Content provided by FirstRanker.com ---
--- Content provided by FirstRanker.com ---
UNIT - IV
- (a) Find the z-parameters of the network shown below.
2 ohms
1 ohm
3 ohms--- Content provided by FirstRanker.com ---
(b) State and explain in detail about the maximum power transfer theorem with an example.
OR - (a) Discuss in detail about transmission and hybrid parameters and also derive their relation for two port network.
(b) Verify reciprocity theorem with a suitable example.
UNIT - V
--- Content provided by FirstRanker.com ---
- (a) Explain in detail about DC transient R-C series circuit.
(b) Describe in detail about trigonometric form and exponential form of Fourier series.
OR - (a) Discuss response of R-C networks for pulse excitation.
(b) Explain in detail about the transient response of R-L circuit for sinusoidal excitation.
--- Content provided by FirstRanker.com ---
*****
--- Content provided by FirstRanker.com ---
This download link is referred from the post: JNTU Anantapur B-Tech 1-1 last 10 year question papers 2010 -2020 -All regulation- All branches- 1st Year 1st Sem