Download AKTU B-Tech 2nd Sem 2015-16 202EAS Engineering Chemistry Question Paper

Firstranker's choice

Printed Pages: 4

www.FirstRanker.com

--- Content provided by‌ FirstRanker.com ---

(Following Paper ID and Roll No. to be filled in your Answer Books)

Paper ID: 199221 Roll No.

B. TECH.

Theory Examination (Semester-II) 2015-16

ENGINEERING CHEMISTRY

--- Content provided by‍ FirstRanker.com ---

Time: 3 Hours Max. Marks: 100

Section-A

Q.1 Attempt all parts. All parts carry equal marks. Write answer of each part is Short. (2×10=20)

1. Boiling Point of water (H2O) is higher than that of Hydrogen Fluoride (HF). Explain why.
2. Define the Symmetry elements of a crystal. Explain the lattice plane and the unit cell in sodium chloride crystals.

--- Content provided by‍ FirstRanker.com ---

3. Account for the fine structure in H-NMR Spectrum of C-H protons in ethanol (CH3 CH2 OH).
4. Natural Rubber needs vulcanization. Give Reasons.
5. What is meant by calorific value of a fuel?
6. Write short note on biomass.

Section-B

--- Content provided by‍ FirstRanker.com ---

Q.2 Attempt any five parts from the following (10×5=50)

1. The density of NaCl is 2.163 g/cc. Calculate the edge of its cubic cell, assuming that four molecules of NaCl are associated per unit cell.
2. Calculate the mass of air needed for complete combustion of 5.0 kg of coal containing 80% carbon 15% hydrogen and rest oxygen.
3. Explain the corrosion phenomenon involving oxide film growth law.
4. 1. S_N1 lead by racemic mixture. Where as S_N2 gives rise to inverted product.

   --- Content provided by​ FirstRanker.com ---

   2. Optical isomerism of lactic acid.
5. Define infrared spectroscopy? Describe the various molecular vibrations in the technique.

Section-C

Q.3 Attempt any two questions from this section (15×2=30)

--- Content provided by​ FirstRanker.com ---

1. What are the fullerenes? Discuss their properties and uses.
2. Calculate the bond order of N2^-, CO, NO, and O2⁺.

Q.4

1. How is then a solid fuel determined using bomb calorimeter experiments?
2. Why is it conventional to express hardness of water in terms of CaCO3 at the international level? Write other units also.

--- Content provided by FirstRanker.com ---

Q.5.

1. What are corrosion inhibitors? Explain with examples how anodic and cathodic inhibitor provide protection against corrosion.
2. Sample of coal contains C=93%, H=6% and ash=1%. The following data was obtained when the above coal was tested in bomb calorimeter.
   1. Wt. of coal burnt=0.92 g
   2. Wt of water taken=2200g.
   3. Water equivalent of bomb calorimeter=550g

   --- Content provided by‌ FirstRanker.com ---

   4. Rise in temperature=2.42°C
   5. Fuse wire correction = 10.0 cal
   6. Acid correction = 50.0 cal.
   Calculate gross and net calorific value of the coal, assuming the latent heat of condensation of steam as 580 cal/g.
3. Explain Zeolite process of water softening.

--- Content provided by⁠ FirstRanker.com ---

www.FirstRanker.com