Download PTU B.Arch 2020 March 3rd Sem 70419 Structure Design I Question Paper

Roll No. [T T T T] Total No. of Pages : 03
Total No. of Questions : 09

B. Architecture (2012 & Onwards) (Sem.-3)

--- Content provided by​ FirstRanker.com ---

INSTRUCTIONS TO CANDIDATES :

--- Content provided by‍ FirstRanker.com ---

1. Attempt SIX questions. Q. No. 1 is COMPULSORY. Attempt any FIVE from the rest.

1. a) What do you mean by Bending stress?
   b) What is difference between column and beam?
   c) What is difference between gross bearing capacity and net bearing capacity?
   d) What is difference between short column and slender column?
   

   --- Content provided by⁠ FirstRanker.com ---

   e) What is difference between tensile stress and bending stress?

1. Design brick foundation for wall W1
   Assume bearing capacity of soil for foundation 900mm below natural Ground Level.

FirstRanker.com

--- Content provided by⁠ FirstRanker.com ---

1. Calculate the base pressure diagram developed in brick retaining wall of following case?

FirstRanker.com

1. Explain middle third rule? Find base pressure for following diagram.

Base resting on elastic pad length is 4m and width is 0.1m (eccentricity of load is 0.7m)

1. Design a brick column for compressive load of 100kN and bending moment 10kN-m
   

   --- Content provided by‍ FirstRanker.com ---

   Assume safe compressive stress of bricks 90kG per square cm.

1. Find factor of safety against overturning for figure no.3.

FirstRanker.com

1. Explain rankine formula for minimum depth of foundation. What will be the minimum
   depth of foundation.for maximum stress on soil below foundation 90 kN/square meter,
   

   --- Content provided by⁠ FirstRanker.com ---

   assume angle of repose of soil - 30 degree?

1. Write short note on following :
   a) Moment of inertia.
   b) Effective length of column
   c) Moment of resistance
   

   --- Content provided by​ FirstRanker.com ---

   d) Shear stress in beam

1. A timber beam, 5m long, section depth 200 and width 200mm is simply supported on
   edges, find the bending tensile and compression stresses if a UDL of 2kN is applied on it.

NOTE : Disclosure of Identity by writing Mobile No. or Making of passing request on any
page of Answer Sheet will lead to UMC against the Student.

--- Content provided by FirstRanker.com ---

FirstRanker.com