FirstRanker.com

Search results for: “ic”

  • ISRO Placement Paper July 2010

    Isro latest paper july 2010

    1. An LTl system has the input signa| x(n).Which of the following sequence of operations is most appropriate to get output y(n) : x(n – MIL)’
    ailnterpotation by L, Delay by M, Decimation by L
    $ Delaj by M,Interpolation by L, Decimation by M
    .jn”.irrruiion by L, Delay by M,Interpolation by L
    i; trrr.rpolation by L, Decimation by L’ delay by M
    consider a lorv passr andom processw ith a white noise power spectral density
    Sx(ro)=N /2 where -ZnBSruo< ZnB
    0 elsewhere

    2. The Auto-correlation function Rx(t) is
    a) 2NBsinc(2nB.r’1
    b) nNBsinc(ZnBr)
    c) NBsinc(ZnBt)
    d) none ofthe above

    3. Pole-zeroptotofadigitalfi|terisshownbelow,whatisthetype offilter?
    a)Low Pass b) High Pass c) Band StoP d) AII Pass

    4. Determinet hc DTFT of the sequenceyl nl : (n+l)u” ulnl’ laf < I ‘ u[nl is unit step sequence.
    a) Y(d’) :l l(l – o c-ju’)t
    b)Y(d’):ll(l+o”i’)’
    .i via9 =c/r (l – o “-i’)t
    d) none ofthe above

    5. The function f(t) has the Fourier transform g(crl)’ The Fourier transform of g(t) is
    ^)
    t(r) t ,n b\ t(-r.,r) | 7n
    c) 2zr f(-to) d) none of the above

    6. The purpose of Design for Test (DFT) process in ASIC design flow is
    a) To capture functional errors
    b) To capture manufacturing defects
    c) To capture timing violations
    d) For radiation mitigation

    7. The coupling between the two inductors is increased from zero in the circuit shown. Which of the following statementsi s true?
    Ll2A
    a) The resonant frequency will increase and the Q will dccrcase
    b) The resonant frequency and Q will both increase
    c) The resonant frequency and Q will both decrease
    d) The resonantf requencyw ill decreasea nd the Q will increase

    8. A parallel plate capacitor of 100 pf having an air clielectric is charged to l0 kilovolts. It is then electrically isolated. The plates are pulled away from each other until the distance is ten times more than bcfore. Estimate the energy needed to pull the plates.
    a) 0.O5.Ioules b) 50 .loules
    a)
    b)
    c)
    d)
    c) 500 Joules d) -50.foules

    9. How could Schroedinger’s cquation bc relcvant in the practical rlesign of a Catho6e- Ray Tube?
    a) To optimize the colour quality
    b) To optimize the picture sharpness
    c) It is not relevant,b ecauset he CttT containsn o crystalline lattice structure
    d) Its effects are negligible, as the electron wavelength is very small compared to the spot size

    10. When compared with striptine, the major disadvantage of microstrip line is
    a) Not amenable for printed circuit technique’
    b) More expensive and complex to manufacture’
    c) Bulkier and voluminous.
    d) More likelY to radiate.

    11. The disadvantage of single-stub matching as compared to double-stub matching, is that
    a) The stub position has to be adjustable
    b) Only shunt stub can be used
    c) Only resistive load can be matched
    d) Ut”f”l only in two wire transmission line

    12. A charge Qz =8.854 xlg-e c is located in a vacuum atP2 (2’3’l)’ The force on Qz due to a charge QF4n xl0-3 C at Pr (2,2,1) is r\ Lr
    a)a,Nb)-5.4a*+6.3a”-5.4a,Nc)5.4a–6.3a,-5.4a,Nd)None

    13. If a material contains 1020 molecules/m3, each molecule having a moment of gSt* xl0-27 C-m parallel to an electric field of l0s V/m, then its dielectric constant is
    *)2.2 b)z c) 4 d) 12

    14. If every minor of order ‘r’ of a matrix ‘A’ is zero, then rank of ‘A’ is
    a; greater than ‘r’ b) equal to ‘r’
    .i l”r, than or equal to ‘r’ d) less than ‘r’
    Which of the following is true
    a) The procluct of the -eigenvalucos f a matrix is equal to the trace of the matrix
    b)eigenvalues of a skew-symmetric matrix are real
    c) A is a nonzero column matrix an6 B is a nonzcro row matrix, then rank of AB is one
    d) A system.ofl inear non-homogeneoues quationsi s consistent if and only if the rank of the coefficient matrix is less than or equat to the rank of the augmented matrix

    15. A unit step voltage travels from left to right along an infinite transmission line. It hits an inductive discontinuity at F0. What wilt be the waveform immediately to the left of the discontinuitY?
    28 A lossy open stub having a length of ll32 wavelength, is approximately equivalent to
    a) A small capacitor in shunt with a small resistor
    b) A small capacitor in shunt with a large resistor
    c) A small inductor in shunt with a small resistor
    d) A targe inductor in shunt with a large resistor
    a) Positive spike on a unit steP
    c) Attenuated unit steP
    29 Ampere’s law relates
    a) Electric field and Charge
    c) Magnetic field and Current
    b) Unit step with reduced rise time
    d) Magnified unit step
    b) Electric field and Current
    d) Magnetic field and Charge

    16. Across which type of boundary does the electric field have a continuous tangential component?
    b) Current free boundary
    d) Charged boundary
    b) n!/(s+a)”*r
    d) 1/(s-a)”*l

    17, the partial differential equation
    b) Hyperbolic
    d) Nature connote be Predicted
    a) Charge free boundary
    c) Any boundary

    18. Laplace Transform of eu’tn is
    a) n/(s-a)””1
    c) n!/(s-a)n*r
    For-oo<x<oo&-lcy<
    *’#+1-yz){fi:ai’
    a) parabolic
    c) Elliptic {4

    19. A communication channel with Additive White Gaussian Noise, has a bandwidth of 4 kHz and SNR of 3ldB.Its channel capacity is
    a) 1.6 kbps b)20 kbps c) 32 kbPs d) 256 kbps

    20. An angle modulated signal with caritr frequency o. :27t x 10s is described by the equations (t) : 10 cos( to.t + 5 sin(30002rt+) 10 sin(2000nt)) . what is the frequency deviation Af ?
    a) 12387.32H2 b) 17500 Hz c) 20000 Hz d) 15000 Hz

    21. A coaxial transmission line carrying an RF signal is perfectly matched to the load. Considert he cross-sectiono f the line, at a plane where the instantaneousv oltagei s at its maximum value. How will the curl of the E-field vary over this cross-section?
    a) Increasesfr om the centert o the outer conductor
    b) Decreasesfr om the center 6’tne outer conductor
    c) Zero everywhere
    d) Constant value proportional to the llF voltage

  • Accenture Placement paper July 2010

    Accenture Paper on 23rd July 2010 @ KIIT, Bhubaneswar
    The entire selection is divided into 4 phases:

    1. Written test
    2. Group Discussion
    3. Technical interview
    4. HR interview

    WRITTEN TEST (23rd July 2010, location- KIIT, Bhubaneswar, 2:00pm)

    This is completely an elimination round.

    55 questions were there and 60 minutes time. It consisted of three sections

    i) English(20 questions)

    a) Fill in the blanks with preposition and articles. Prepare from ?wren and martin?.
    b) Questions on synonyms and antonyms.
    c) Two reading comprehensions not must difficult and related to some technical topics like RAID, Internet protocol, networking etc

    ii) Aptitude(20 questions)

    a) Venn diagram (very very important)

    b) Test knowledge of union and intersection (A U B) and (A?B)
    c) Simple problems on time and distance, work, direction related questions, clock, profit & loss, probability, ratio & proportion, simple multiplication like 123456787* 19=?
    d) Age related problems

    e) Try to solve this section as soon as possible its very important prepare for this section. This is the deciding one.

    iii) Reasoning(15 questions)

    a) Check whether given three words are alike , 1st word and 2nd word are alike, or all are different (very simple even a 5 year child can solve)
    b) A problem will be given followed by two statements. You have to answer whether the problem can be solved by using statement 1, statement 2 , both statement 1 and 2, cannot be solved.(again very very simple)
    c) If + is replaced by *, * is replaced by/ , / is replaced by -. Then 2*2+3-4/3=?( very simple you need little practice)
    d) Relationship questions(abc is son of brother of xyz????like this )
    e) If MANGO is replaced with OCPIQ, then what will be CHHERY?
    f) This section is scoring and you can easily get 10/15.
    g) If you are not good in aptitude start with this section, it will boost ur confidence.
    iv) Essay: extra five minutes will be given to write an essay on a topic(100 words). Don?t take it lightly.

    GROUP DISCUSSION (23rd July 2010, KIIT, Bhubaneswar, 06:00pm ) :

    This was the simplest one. 350/500 cleared this round. I was in a group of 16 people and our topic was ?India as a global leader?. Each of us were given 1 minute time to speak. In my group all of us get selected. Some tips you should follow in GD:

    a) Speak only when your chance comes. Never never try to cross check or interrupt while other is speaking.
    b) Whatever is your point speak with confidence and don?t try to copy from others.
    c) Make eye contact with all others while speaking. Even if you don?t know much about the topic not a problem. Only your communication is checked.
    d) Speak less and politely and wait for your turn. Everyone is given a fair chance.
    e) Just tell 2 or 3 points and you will be selected.

    TECHNICAL INTERVIEW (24th July , 2010, KIIT, Bhubaneswar, 04:00pm):

    Q. write a program to find whether a number is prime or not?
    Q. write a program to find whether a number is prime or not?
    Q. what is run time polymorphism and encapsulation?
    Q. what is php? and why you have choosen php for designing website?
    Q. what is the difference between c++ and java?
    Q. what is the difference between interface and inheritance?
    Q. What do you know about Accenture? Why you want to join Accenture?

    Accenture Paper on 9th July 2010 @ SKNCOE, Pune

    In English, there were 5 questions on articles, 5 fill in the blanks and there were two passages for reading comprehension. In Data interpretation, there were simple problems like:

    Odd man out:

    67896532 6789632 67896532 67896532

    There were also several questions on:
    If +=*, -=/, *=- and /=+ then what is the value of 5+6*3-2/9 ?

    Then there was technical interview.

    Questions asked:
    ? Introduce yourself.
    ? Draw Kmap of any gate. (I drew for AND gate.)
    ? How can u obtain a 4*4 KMAP?
    ? Which circuits will u need for the same?
    ? Tell me different subjects u have studied.
    ? What is 8087?
    ? U have written a very good essay. Can you comment about the same?
    ? I can see from your marksheets that you have a very good percentage in your 10th standard but not so well in 12th. Why is this so?
    ? Do you want to ask something? (Don?t loose this opportunity and always ask something about the company)

    The HR round

    Questions asked:

    ? Introduce yourself.
    ? Why Vishwanathan Anand is your favourite player?
    ? What does your father and mother do?
    ? Why Accenture?
    ? Why do you want to become a perfectionist in your life?
    ? I can show 5 imperfections in you at this moment.
    ? Will you accept a person with imperfections?
    ? Then he asked to give the location preference.

error: Content is protected !!