Download PTU B-Tech Bio Technology 2020 Dec 3rd Sem 55075 Transport Phenomenon Question Paper

Download PTU (I.K.Gujral Punjab Technical University (IKGPTU)) B-Tech (Bachelor of Technology) BT-Bio Technology 2020 December 3rd Sem 55075 Transport Phenomenon Previous Question Paper

Roll No.
Total No. of Pages : 03
Total No. of Questions : 09
B.Tech. (BT) (2012 to 2017) (Sem.?3)
TRANSPORT PHENOMENON
Subject Code : BTBT-305
M.Code : 55075
Time : 3 Hrs. Max. Marks : 60
INST RUCT IONS T O CANDIDAT ES :
1 .
SECT ION-A is COMPULSORY cons is ting of TEN questions carrying TWO marks
each.
2 .
SECT ION-B c ontains F IVE questions c arrying FIVE marks eac h and s tud ents
have to atte mpt any FOUR q ues tions.
3 .
SECT ION-C contains THREE questions carrying T EN marks e ach and s tudents
have to atte mpt any T WO questio ns.
SECTION-A
1.
Write Briefly :
a) What is the driving force for heat and momentum transport?
b) Define Newtonian and non-Newtonian fluids.
c) What are the units of mass diffusivity?
d) Define Reynolds number.
e) Write Newton's law of viscosity.
f) How does the viscosity of gases vary with temperature?
g) What are the various mechanisms of transport?
h) Write down the units for rate of heat flux.
i) What is the general transport equation for momentum, heat and mass transport?
j) What is Biot number? What is its significance?
1 | M- 55075
74

SECTION-B
2.
Consider a system having two parallel plates in figure 1. Compute the steady state
momentum flux yx in lbf /ft2 when the lower plate velocity is 1.5 ft/s in the positive x
direction, the plate separation is 0.01 ft and the fluid viscosity is 10cp.
Upper plate is at rest
u = 0
y
x
0.001ft
w
u = 1ft/sec
FULLY DEVELOPED LAMINAR FLOW
Fig. 1
2
a
3.
The potential for a flow around a cylinder of radius a is given by ux 1
2
2
x y
where x and y are the rectangular coordinates with the origin at the middle. Derive an
expression for stream function .
4.
A solid sphere of naphthalene (A) with a radius of 2.5 mm is surrounded by still air (B) at
300 K and 1 atm. Take the surface temperature of the naphthalene as 300?K and its vapor
pressure at this temperature as 0.104 mm Hg. The diffusivity of naphthalene in air at 318?K
is 6.92 ? 10?6 m2 / sec. Determine the rate at which naphthalene evaporates.
5.
Consider an incompressible liquid in a cylindrical vessel which has been undergoing
constant angular motion for a time interval which is of such a duration that the liquid has
assumed a fixed orientation in the vessel. Show that at steady-state, the free surface forms a
paraboloidal surface given by Z ? Z0 = (2 / 2g) r2. Assume that the viscosity of the fluid is
constant.
6.
Derive the equation of continuity for a binary mixture for the following case: Case:
equation describes the concentration profiles in a binary diffusing system.
cA
*
.
c v
cD
x
R
A
. AB A A
t
2 | M- 55075
74

SECTION-C
7.
In a gas diffusion experiment chloropicrin (CCI3NO2) is kept in a cylindrical test tube. A
gas is passed through the open end of the tube. What is the rate of evaporation (in g.hr1) in
air at 25?C? Total pressure = 770 mm; Hg Diffusivity = 0.088 cm2 Sec?1; Vapor pressure
= 23.81 mm; Hg Distance from liq. Level to top of tube = 11.14 cm
Density of chloropicrin = 1.65 g cm?3; Surface area of liq. exposed to air = 2.29cm2.
8.
A 15 cm long copper fin of diameter 3 mm is attached to a vertical wall at 500 K and is
projected in a room where air is at 300 K. The heat transfer coefficient at the fin surface is
700 W/m2 K and conductivity of fin material is 450 W/m K. Calculate :
a) Heat loss from fin
b) Fin efficiency
c) Fin effectiveness.
9.
Two large tanks are connected by a truncated conical duct as shown in Figure 2. The
variation in the diameter as a function of position is represented by D(z) = 0.006 + 0.02z.
Gas compositions in the tanks are given in terms of mole percentages. The pressure and
temperature throughout the system are 1 atm and 25?C, respectively, and DAB = 3 ? 10?5
m2/s.
a) Determine the initial molar flow rate of species A between the vessels.
b) What would be the initial molar flow rate of species A if the conical duct were replaced
with a circular tube of 8 mm diameter?
20 cm
TANK 1
TANK 2
90% A
25% A
10% B
75% B
z
Fig. 2
NOTE : Disclosure of Identity by writing Mobile No. or Marking of passing request on any
paper of Answer Sheet will lead to UMC against the Student.
3 | M- 55075
74

This post was last modified on 13 February 2021