Download AKTU (Dr. A.P.J. Abdul Kalam Technical University (AKTU), formerly Uttar Pradesh Technical University (UPTU) B-Tech 8th Semester (Eight Semester) 2018-19 NME055 Advanced Welding Technology Question Paper
Printed Pages: 01 Sub Code: NME055
PaperId: RollNo.| | | | | | | | | | |
B TECH
(SEM-VIII) THEORY EXAMINATION 2018-19
ADVANCED WELDIN G TECHNOLOGY
T ime: 3 H ours T otal M arks: 100
Note: 1. Attempt all Sections. If require any missing data; then choose suitably.
SECTION A
Attempt all questions in brief. 2 x 10 = 20
What types of welded joints used in welding?
What do you mean by cladding & surfacing?
Define welding? Make comparison with other joining process?
Write short note on are blow in welding process?
What is weld distortion and its prevention?
Explain weld affected zone?
1
a.
b.
c.
(1. Describe various welding symbols.
e.
f.
g.
h. List different type of brazing techniques available? Explain any one in detail.
1. What is physics of arc welding?
j. Define reclamation welding?
SECTION B
2 Attempt any three of the following: 10x3=30
a Make comparison between Laser beam welding and electron beam welding?
b. Explain type of underwater welding and their working mechanisms?
0 List type of weld defects explains any two with neat diagram?
d Explain the effects of various alloying elements on weldability.
e Write short note on use of Transformer,Rectifier and Generators in welding.
SECTION C
3. Attempt any one part of the following: 10x1=10
a. What do you mean by heating and cooling rate? How it affects the properties of weld.
b. What are the methods used for measuring the stresses in weld structure? Explain any one of
them.
4. Attempt any one part of the following: 10x1=10
a. What do you mean by metalizing and hard facing? Explain process giving its advantage and
applications.
b. Write short note on
i. Welding of cast iron.
ii. Welding of low carbon steel.
iii. Welding of aluminum.
5. Attempt any one part of the following: 10x1=10
a. Discuss the principle and working of ultrasonic inspections .Also describes its advantage,
limitations and applications.
b. Define cracking of weld? Explain hot cracking and cold cracking? List the rules that must be
followed to avoid cracking?
6. Attempt any one part of the following: 10x1=10
a. What do you understand by explosive welding; Write its advantage, disadvantage and
applications in detail?
b. Explain the principle and working of F CAW welding? Differentiate MIG &FCAW? What
variables affect weld quality of F CAW welding?
7. Attempt any one part of the following: 10x1=10
a. The arc length voltage characteristic is given by expression V:24+4L (L=Length of arc in
mm).The volt ampere characteristics of power source can be approximated by a straight line
with open circuit voltage 80V and short circuit current 600A determine optimum arc length
and maximum power.
b. Explain in detail the mechanism and types of metal transfer in various arc welding
processes.
_ Page 1 of 1
www.FIrstRanker.com
This post was last modified on 30 January 2020